User manual FAGOR 5H-741N

[. . . ] 6 Safety recommendations How to install your oven Electrical connections Dimensions for installation use P. 9 How to use your oven The oven programmer How to set the clock How to cook straightaway How to programme the cooking How to use the timer P. 16-17 Changing a bulb Cooking methods Cleaning the oven cavity Pyrolysis explained When to clean by pyrolysis Starting pyrolysis P. 20 Troubleshooting Throughout this manual, indicates safety recommendations, indicates advice to help you make the best use of your oven 2 99638961_A_FR GB. [. . . ] € The blue wire (neutral) going to the terminal marked N. € Tighten the screws and check, by tugging on each wire, that they are firmly connected. € Close the trapdoor using the two screws. We cannot accept any liability in the event of an accident resulting from non-existent or faulty earthing. Qxp 02/03/2006 10:38 Page 9 How do you install your oven?Useful dimensions for installing your oven EN 577 600 585 577 The oven can be installed under a work top or in a column of cabinetry (open* or closed) having the appropriate dimensions for built-in installation (see adjacent diagram). Your oven has optimised air circulation that allows it to achieve remarkable cooking and cleaning results if the following guidelines are respected: • Centre the oven in the cabinet so as to guarantee a minimum distance of 5 mm between the appliance and the neighbouring cabinet. € The material of the built-in cabinetry must be heat resistant (or be covered with such a material). € For greater stability, attach the oven in the cabinet with two screws through the holes provided for this purpose on either side of the front inner panel (see diagram). To do this: 1) Remove the rubber screw covers to access the mounting holes. 2) Drill a Ø 3 mm hole in the cabinet panel to avoid splitting the wood. 4) Replace the rubber screw covers (they also serve to absorb the shock caused by closing the oven door). (*) If the cabinet is open, its opening must be 70 mm (maximum). To be certain that you have properly installed your appliance, do not hesitate to call on a household appliance specialist. The oven programmer 1 7 6 2 3 5 4 8 1 2 3 4 5 10 9 6 7 8 10 ECO (economical) cooking indicator Clock and cooking time display Temperature display Door locked indicator Cooking time symbol Button for setting timed programmes End of cooking time symbol Timer symbol 9 10 Buttons for adjusting the time 99638961_A_FR GB. qxp 02/03/2006 10:38 Page 11 How to use your oven 2. How to set the clock EN a) When the oven is first switched on at the mains • The display blinks to 12h00. € Press on the and buttons until the correct time is shown (Keeping a finger on the button, rather than tapping it, is quicker) The example shows 12. 30 Registration of the amended time is automatic after a few seconds. -> the display no longer flashes b) Altering the clock • Press on both buttons together for a few seconds until the display blinks. And 1 1 The time display blinks and you can alter the time. Press on both and buttons together to obtain the correct time (back or forwards). [. . . ] When to clean by pyrolysis If your oven smokes when the pre-heat feature is on or if there is a lot of smoke during a cooking cycle run the pyrolysis cycle. You can also use this feature if there is an unpleasant smell of cooking when the oven is cold. FOOD WITH LITTLE Biscuits, vegetables, cakes SPATTERING quiches, soufflés FOOD THAT SPATTERS FOOD THAT SPITS BADLY Meat, fish (in an open dish) stuffed vegetables Large pieces of meat on the spit You do not need to use pyrolysis feature Use the pyrolysis feature after 3 oven uses If a lot of spitting occurs, run the pyrolysis feature afterwards. Do not wait until the oven is coated in dirt before cleaning it. [. . . ]