User manual FAGOR 5H-760

[. . . ] Introduction What does your oven look like?Safety recommendations How do you install your oven?Close-up of your programmer How do you set the clock on the oven?How do you program for immediate cooking? [. . . ] ⷠCarefully twist together the strands. ⷠLoosen the screws from the terminal board and remove the power cord to be replaced. ⷠIntroduce the power cable through the side of the cover in the cable clip located to the right of the terminal board. ⷠConnect the power cord wires in accordance with the written markings on the terminal board. The green-yellow coloured ground wire should be connected to the terminal. Screw down tightly the screws on the terminal board and check the connection by pulling on each wire. Close the inspection flap using the two screws. We cannot be held liable for any accident resulting from an inexistent, defective or incorrect ground lead. Disconnect your oven before performing any task on the bulb to avoid the risk of electric shock and, if necessary, let the appliance cool down. Bulb specifications: - 15 W - 220-240 V - 300°C Unscrew - E 14 cap View port c) Replace the bulb then reposition the view port and reconnect your oven. To unscrew the view port and the light, use a rubber glove, which will make disassembly easier. The oven can be installed under a work top or in a column of cabinetry (open* or closed) having the appropriate dimensions for built-in installation (see adjacent diagram). Your oven has optimised air circulation that allows it to achieve remarkable cooking and cleaning results if the following guidelines are respected: · Centre the oven in the cabinet so as to guarantee a minimum distance of 5 mm between the appliance and the neighbouring cabinet. ⷠThe material of the built-in cabinetry must be heat resistant (or be covered with such a material). ⷠFor greater stability, attach the oven in the cabinet with two screws through the holes provided for this purpose on either side of the front inner panel (see diagram). 4) Replace the rubber screw covers (they also serve to absorb the shock caused by closing the oven door). (*) If the cabinet is open, its opening must be 70 mm (maximum). To be certain that you have properly installed your appliance, do not hesitate to call on a household appliance specialist. Display area for clock and cooking times Cooking time icon Cooking end time icon Independent timer Touch control for accessing various time setting programmes How does your oven work?Set the time by pressing the or touch controls (holding your finger on the touch control allows for rapid number advancement). Simultaneously press the and touch controls for a few seconds until the display flashes. ⷠAdjust the clock setting with the touch controls. [. . . ] If you hold down the touch control, you will obtain rapid advance of the numbers. The countdown begins a few seconds after you have finished setting the time and can be viewed at all times on the display. when the selected time has expired , a series of beeps is emitted (display 0:00). The beeping can be stopped by pressing the button of your choice. [. . . ]