User manual FAGOR 6CFI-5GLST

[. . . ] Dear Sirs and Madams, You have purchased a gas hob designed to be fitted in a kitchen worktop. Thanks to its state-of-the art technological and aesthetic solutions the gas hob perfectly matches any interior allowing the user to arrange the kitchen room according to his or her needs and preferences. It is designed to work together with an appropriate control panel or oven manufactured by our company. the hob features gas burners and ignitors switched on by gas tap knobs. [. . . ] 4 and 5) After affixing the gasket place the hob in the cavity in the worktop 1 and press down tightly so that sealing joint is perfectly closed 6. Fix the hob underneath to the worktop 1 with clamps 3 and screws 4 supplied in the accessory bag 7. 6) should be installed under the worktop to protect the user from accidentally touching the hot hob from beneath. The shelf should be fitted after installing the hob in the worktop. The connection of the hob to the gas supply system should be made in accordance with the regulations in force. All activities involved in connecting the hob to the gas supply system, adjusting the taps and replacing nozzles should only be performed by a properly certified person 3. Before beginning the connection operation make sure that the gas valve is closed!Gas supply system should be connected to the pipe with appropriate fittings. CONNECTING THE HOB TO NATURAL GAS SUPPLY When connecting the hob to natural gas supply use an elbow with gasket and seal the taper thread (at the outlet) with Teflon band. The hob may be connected to the internal supply system with a rigid connection or a flexible metal tube. 7 CONNECTING THE HOB TO AN LPG CYLINDER Do not install the appliance in the basement or in any other room whose floor is below the ground level as LPG is heavier than air and accumulates at the floor level. The cylinder should be located in an easily accessible place, positioned vertically and secured against falling over. When connecting the appliance to the cylinder use a flexible tube. To connect the appliance use the LPG tip with a gasket as shown in fig. Each time after connecting the hob to LPG cylinder check the soundness on high pressure side, check the cylinder valve for soundness and the connection of regulator with the cylinder and its operation. The soundness of all connections and the cylinder valve maybe pre-checked by applying soap solution on the said points with the normal working pres-sure. Under no circumstances can the gas soundness be checked by means of a naked flame (e. Regularly, every six months, check the condition of the tube and soundness of its connection to the end elements. When adjusting the taps do not unscrew the needle completely. Before beginning these activities you must: ­ shut down the cock shutting off the gas supply system or cylinder from the hob, -shut down all the taps in the hob, ­ disconnect the hob from the mains. Then: ­ remove the burners' lids and rings, ­ remove the nozzles with socket wrench no. 7 and replace them with new ones in accordance with table2, ­ put burners' rings and lids back, ­ adjust the taps and check the connections for soundness Then: ­ open the gas flow with a knob and light the adjusted burner, . [. . . ] Act similarly if any liquid including a lot of sugar spills; on the hot hob surface sugar melts very quickly, which may result in permanent stains. Discolouring of the hob does not affect its proper functioning ­ After cleaning, the hob may be covered with a protection agent, eg CERA FIX Gas burners, ignitors and thermocouple tips should be cleaned after each spillageand regularly to remove cooking residuals and dirt. To clean burners remove the lids 1 and rings 2 (Fig. 16), put them in warm water with detergent for some time and then wash each part of the burner separately. [. . . ]