User manual FAGOR 7CFT-NERO ISL

[. . . ] Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Note: the elements marked with the symbol "(*)" are optional accessories supplied only with some models or elements to purchase, not supplied. Do not connect the appliance to the mains until the installation is fully complete. [. . . ] Permanently fix the cooker hood to the suction group with the 6 screws. Using a pencil, draw a line on the wall, extending up to the ceiling, to mark the centre. Rest the drilling template against the wall: the vertical centre line printed on the drilling template must correspond to the centre line drawn on the wall, and the bottom edge of the drilling template must correspond to the bottom edge of the hood. Place the lower support bracket on the perforation diagram making it coincide with the traced triangle, mark the two external holes and perforate. Remove the perforation diagram, insert two wall-dowels and fix the support bracket of the hood with two 5x45 mm screws. Adjust the distance of the hood from the wall. Using a pencil mark the cooker hood permanent drill hole inside the suction group (1 or 2 fixing points are necessary for permanent mounting). Insert 1 or 2 wall screw anchors according to requirement. Apply the flues support bracket , , G" to the wall adherent to the ceiling, use the flues support bracket as a perforation diagram (if present, the small slot on the support must coincide with the line drawn previously on the wall) and mark two holes with a pencil. Fix the chimney support bracket to the wall using two 5x45mm screws. Fix the hood into its final position on the wall (ABSOLUTELY ESSENTIAL). If the hood is to be used in ducting version, the other end of the pipe must be connected to a device expelling the fumes to the outside. If the hood is to be used in filter version, then fix the deflector F to the chimney support bracket G and connect the other extremity of the pipe to the connection ring placed on the deflector F. Apply the chimney stacks and fasten them at the top to the chimney support , , G" (20b) using 2 screws (20a) 21. Slide the bottom section of the chimney down until it completely covers the suction unit and slots into the housing provided on top of the hood. Fix the lower section of the chimney with two screws. The standard period of time is 5', at the end of which the hood reverts to speed level 2. To deactivate the function before the set time has elapsed, simply press the "-" button. SPECIAL FUNCTIONS Programming the Clock The clock may be set at any time, apart from when the timer function is active. The clock may be displayed in a 12-hour format, indicating a time between 1:00 and 12:59. The clock may be reset by pressing and holding the "Timer" button for 5 seconds, then pressing the "-" and "+" buttons to adjust the time. The user may increase/decrease the time in steps of 1 minute; however, if the "-" or "+" button is pressed for 1 second, the time is decreased/increased in steps of 5 minutes. [. . . ] Of the charcoal filter must be selected while the motor and light are OFF. charcoal filter excluded: the filter alarm is disabled. Enabling/disabling the sound signal The sound signals may be activated or deactivated by pressing and holding the "Light" button for 5 seconds. remove the filter holder frame by turning the knobs (g) 90° that affix the chimney to the cooker hood. [. . . ]