User manual FAGOR 9CFV92

[. . . ] Make sure that they do not touch the appliance's control panel. Make note of any concerns or reservations on the delivery slip and make sure to keep a copy of this form. -- Your appliance is intended for standard household use. Do not use it for commercial or industrial purposes or for any other purpose than that for which it was designed. [. . . ] The electrical connections are made before the appliance is installed in its housing. Ensure that: - the electrical installation has sufficient voltage, - the electrical wires are in good condition, - the diameter of the wires complies with the installation requirements. This appliance is delivered with a H 05 VVF power cord that has three0. 75 mm2 conductors (neutral , phase and ground). It must be connected to the main power supply (which should be a 220-240 V single phase current) via a CEI 60083 standardised socket that should remain accessible after installation, in keeping with installation guidelines. We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. The fuse for your installation must be 10 or 16A. If the power cable is damaged, call the after-sales service department in order to avoid danger. If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In France these regulations are described in DTU 61. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm at least. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. Fixing to the wall : -Mark a vertical line on the wall centred on the cooktop. -Mark on the wall the three holes that have to be drilled, using the supplied hood suspension hook and observing the recommended distance (part A Pic. -Secure the hood's fixing support, ensuring that it is perfectly level (part A Pic 1). - Before fixing the hood , mount the non-return valve on the motor outlet -Fix the extendable evacuation sleeve (not included) to the motor outlet without impeding the movement of the non-return valve. -Fit and secure the body of the hood on this support with the screws provided for this purpose. 1) - Mark the two holes accordingly - Drill 8 mm diameter holes and secure the duct support bracket, ensuring that it is fixed on the same axis as the hood (oart B Pic 1) - Fix the flat bracket behind the lower duct. [. . . ] (Do not allow them to touch dirty dishes or silverware. To preserve your appliance, we recommend that you use Clearit cleaning products. Clearit offers you professional products and solutions designed for the daily care of your household appliances and kitchens. They are on sale at your regular retailer, along with a complete line of accessories and consumable products. [. . . ]