User manual FAGOR AF3-607 X

[. . . ] Check (for transport reasons) that there is no other supplied material inside the hood (e. ), eventually removing them and keeping them. In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket is available and it is possible to connect a fumes discharge device to the outside (only suction version). Choose the discharge outlet to use: Only filtering version: use ONLY the upper B1 outlet (Fig. [. . . ] Fix the brackets with the screws and threaded bushes (Fig. Note: the position of the brackets can be adjusted during installation, suitably loosening and retightening the screws that fix them to the hood. The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. Connect the electrical plug, where provided, to the an easily accessible outlet in conformity with local standards in force. Where an electrical plug is not provided (for direct connection to electrical network) or is not easily accessible, place a standards approved bipolar switch that provide full disconnection under overvoltage category III conditions, in accordance with the wiring rules. Attention: substituting the supply cable must be carried out by the authorised technical assistance service. Put perforation diagram N3 on the REAR of aesthetic panel J (the arrow on the diagram turned upward towards the UPPER EDGE of the aesthetic panel). 6 Put the steam collector over the aesthetic panel and fix it with 8 screws L. 6 Remount the door on the hood, first on upper guides M1, then on the lower M2. 6 Close completely and re-open the door to check its correct sliding on the guides. Same frequency with which you carry out maintenance of the fat filters) internally and externally. Cover the grill that protects the suction motor with the carbon filter so that the slots on the filter correspond to the pins on the sides of the motor protection grill. Turn the carbon filter clockwise to block them (bayonet fixing). Note: 2 filters are needed in the models with 2 motors. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Prior to touching the light bulbs ensure they are cooled down. If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. The cooker hood should be cleaned regularly (at least with the Never use the hood without the grill mounted!The hood must NEVER be used as a support unless expressly indicated. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] The use of open flame damages the filters and can cause a fire; it must therefore be avoided in any case. Frying must be carried out under control in order to prevent overheated oil catching fire. Keep strictly to the regulations envisaged by the competent local authority as far as the technical and safety measures to adopt for discharging fumes are concerned. the hood is to be cleaned frequently both internally and externally. [. . . ]