User manual FAGOR CG-312

[. . . ] â· Disconnect the appliance from the mains when not in use and before cleaning. Allow it to cool before dismantling and assembling the pieces and before cleaning. â· Do not leave the appliance exposed to the elements (rain, sun, ice, etc. Do not use or place any part of this appliance on or near hot surfaces (e. [. . . ] Clean the hotplate (9) with a damp cloth and do not immerse the coffee machine in water or any other liquid. Before making coffee for the first time, you should make up one or two pots using just water, without coffee or filter, to clean any dust from the coffee machine so that the flavour of the coffee will not be affected. Important advice: the effect will be better if cold water is used at the outset to make the coffee. Place the coffee machine on an even surface, not near an edge. When making coffee, the jug should be placed on the hotplate with the lid on. Filling the water tank Open the lid of the water tank (1), pour the desired amount of water into the jug (8), and then pour all the water from the jug into the water tank. the measurement marks in the tank will show how much water has been poured in. Once the water pipe is aligned with the centre of the filter holder, make sure you place the jug on the hotplate with the lid on. B: When the coffee is made, there will be less coffee than the amount of water originally poured due to the fact that some of the water will have been absorbed by the permanent filter, ground coffee and steam. Open the upper lid (1), insert the water pipe (11) into the tank, remove the filter holder, place filter in the filter holder and place the desired amount of ground coffee in the permanent filter. After making the coffee, remove the coffee filter and clean the filter holder with water. Coffee industry standards state that the proportion of coffee to water is 7g of Unwrap the packaging carefully and remove the coffee machine. Dismantle the filter holder (6) and jug lid (7) and clean them, along with the jug (8) and the anti-drip valve holder (4), in You may adjust this measurement to taste. Caution: You should use exclusively ground coffee for drip coffee makers. Place the filter holder (6) in its place, align the water pipe (11) with the centre of the filter holder and place the upper lid on the jug. Switch the on/off switch on (10), and the on/off light will show that the coffee machine is in operation. After several minutes the coffee machine will heat up and then enter the heat maintenance phase. When the switch is in the 0 position, the coffee machine will cease to operate. You may remove the jug to serve the coffee while the coffee machine is in operation. Then place the jug back on the hotplate and the coffee will automatically flow through the filter holder. Caution: Do not remove the jug from the plate for over 30 seconds otherwise the filter holder will spill over. IMPORTANT: always make sure that your coffee machine is disconnected and the hotplate is cold before cleaning it. [. . . ] Pour the vinegar and water mix into the tank and operate the coffee machine. Wait for all of the solution to pass into the jug. Repeat this operation two or three times, according to how much limescale there is. After removing limescale from the coffee machine, operate it two or three times just with water to eliminate any vinegar residues. [. . . ]