User manual FAGOR CG-414D

[. . . ] To safeguard against electric shocks, do not immerse the appliance, cord or plug in water or any other liquid. Do not allow children or disabled persons to handle the appliance unsupervised. Disconnect the appliance from the mains when not in use and before cleaning. Wait until the appliance has cooled down before assembling or dismantling parts and before cleaning it. [. . . ] Do not place the jug on or near any hot surface (heater, burner, Do not place the jug on any damp or wet surface. Before using your coffee maker for the First time, familiarise yourself with all the parts. 3) and clean them together with the jug (6), the permanent filter (10) and the anti-drip support valve in lukewarm soapy water. Rinse well, dry and reassemble them, attaching the anti-drip support valve correctly to the filter holder To clean inside, operate the coffee maker twice in succession without placing ground coffee in the filter. For this process, follow the instructions under the section entitled "Preparing the coffee". Fill it with clean, cold water up to the desired level. Fill the filter (10) with the desired amount of ground coffee and close the lid. We suggest one dessertspoon of ground coffee per cup of coffee. After using the coffee maker several times, you may adjust the amount of coffee to taste. Make sure that the jug lid opens the anti-drip valve, otherwise the filtered coffee will Not filter through to the jug and will overflow out of the filter. When the jug is empty, unplug the appliance from the mains and wait approximately ten minutes for the coffee maker to cool down before making more coffee or cleaning it. By default, the coffee maker will switch off automatically after one hour and 59 minutes. If you so wish, you may set the coffee maker to disconnect automatically. To do so, press the on button (12) until the red pilot light (11) starts to flash. Release the button and change the desired disconnection time with the h (hours) (17) and m (minutes) (16) buttons. Then press repeatedly until you reach the desired time. Recommendation: Just before reaching the correct time, repeatedly press the "h" or "m" button briefly to avoid going past the desired time. , power failure, cord is unplugged), clock and programmed time are stored for 1 minute. To set the start time, press the setting button (13) until the green pilot light lights up. After three seconds, the green pilot light will go off. once set , press the setting button (13) to activate automatic operation. The green pilot light will come on and the time selected will flash on the display screen. [. . . ] Repeat this operation two or three times, depending on how much limescale there is in your coffee maker. After you have removed the limescale, operate your coffee maker two or three times with just water so as to remove any vinegar left behind. We recommend that you remove the limescale from your coffee maker every four weeks. Local authority differentiated waste collection centre or to a dealer providing this service. [. . . ]