User manual FAGOR CG-810

[. . . ] The manufacturer accepts no responsibility for any damage resulting from the appliance not being connected to an earth installation. Before using the appliance for the first time, make sure that the mains voltage in your home corresponds to that indicated for the coffeemaker. ⷠIn order to avoid electric shocks, do not submerge the appliance, cable or plug in water or any other liquid. ⷠDo not let children or the handicapped use the appliance without supervision. [. . . ] To do this, follow the instructions given in the section entitled "Making coffee". Fill with clean, cold water to the required level. Do not exceed the indicated maximum level mark. ⷠFill the filter (3) with the required quantity of ground coffee and close the lid. we recommend one dessertspoon of coffee per cup. After using the coffeemaker a few times, you may wish to adjust the amount of coffee used according to individual taste. Ensure that the jug lid opens the anti-drip value (6), otherwise the filtered coffee will not drip down into the jug and will overflow from the filter. The liquid that drips into the jug is hot and may cause burns if the jug is accidentally broken. To avoid breakage, take the following safety precautions: · do not allow all the liquid to evaporate. ⷠDo not use a broken jug or a jug whose handle is loose or weak. Replace if any signs of damage are detected. A tiny crack or breakage of a small piece of the glass may cause the jug to shatter and to contaminate the liquid with splinters of glass. ⷠDo not clean the jug with an abrasive scourer or any cleaning products that may scratch or otherwise weaken the glass. ⷠThe jug is designed for use with this appliance. Do not place it on or near hot surfaces (heaters, burners, hobs, hot ovens, microwaves, etc. Do not place the jug on wet or cold surfaces. When the filtering process is completed, the heater plate will keep the coffee warm. ⷠIf you wish to pour a cup of coffee before the filtering process has finished, remove the jug from the heater plate, pour and then replace immediately. ⷠWhen the jug is empty, turn the start/stop switch off (the pilot light will go out), unplug the appliance leave to cool for 10 minutes before repeating the coffee-making operation or cleaning. Do not use any other liquid except water. ⷠTo prevent the water in the filter from overflowing the jug lid should be correctly fitted in order to ensure that the anti-drip value is opened, enabling the water to pass through to the jug. ⷠLeave the coffeemaker to cool before refilling the deposit. [. . . ] Clean the outside of the coffeemaker with a damp cloth. Depending on the hardness of the water in your area and the frequency of use, the appliance's tubes may become obstructed by lime. You will know that this has occurred when the filtering process starts taking longer than normal. To prevent this, you should decalcify your coffeemaker by either using a commercial decalcifying agent specially designed for coffeemakers, or by following the instructions given below: Fill the jug with a 1/4 vinegar 3/4 water solution. [. . . ]