User manual FAGOR CR-10

[. . . ] ⷠPeople with nervous dysfunctions should not use the appliance if they are unaccompanied. ⷠBefore switching the appliance on, fill the deposit with water. ⷠThe drip tray and the grille must be correctly fitted before switching the coffee machine on. When closing the control lever, take care not to put your hands in the filter holder. [. . . ] 2 single weak measures - Filter for single coffee measure (K) (Fig 7): 1 single hard measure (E. Move the filter lock (R) backwards and fit the chosen filter into the filter holder (M) (Fig. 8) and insert the quantity of coffee or your chosen measure in the filter IMPORTANT - Press the coffee with the measurer (L). Once pressed, the level must be below the maximum level indicated inside the filter for 1 or 2 cups. Before using the coffee machine for the first time, clean the filters with water. It is also necessary to clean the coffee machine inside. To do this, fill the deposit with water and run it through without coffee until the deposit is empty. Remove the deposit to fill it with cold water and fit it back in the coffee machine (Fig 2). ⷠPlug in the coffee machine and switch it on using the on / off switch (E). The red light (C) will come on to show that the coffee machine is on. ⷠFit the empty filter holder (M) in the head (Q) and turn it from left to right (Fig 3). ⷠWhen the green light (D) comes on the coffee machine will have reached the correct temperature and it will be ready. - Clean off any coffee remaining on the edge of the filter holder. - Add the single weak measure using the coffee measure (L) Once the filter holder has been fitted into the head, turn it to the right (Fig. Put one or two cups under the filter holder (M) and when the green light (D) comes on, press the coffee switch (F). The coffee will start to come out of the filter holder (M) (Fig. When there is sufficient coffee, press the switch (F) again and the coffee flow will stop. Remove the filter holder (M) from the block and keep the filter lock (R) forward, clean out the used coffee (Fig. 11) When you have finished using the coffee machine, turn off the switch (E) and unplug the coffeemaker from the mains. To prepare a cappuccino you must: · Insert the steamer (O) approximately 3 cm into the milk and hold it in this position. Use good quality coffee which has been properly ground. You can also use weak single measures and ESE type hard single measures Pre-heat the filter and the cups. [. . . ] Then place a container which is large enough on the drip grille (H) under the filter holder (M). Press the switch (E) to turn the coffee maker on and press the button (F). Let around 1/3 of the deposit flow out through the coffee outlet. ⷠThen let the solution work for around 15 minutes with the coffeemaker switched off. [. . . ]