User manual FAGOR CR-1000 2008

[. . . ] When the appliance is no longer useful, after unplugging it from the mains you should cut its cord so that it cannot be used again. This appliance is designed for making coffee and heating up liquids; on using it be very careful to avoid burns from the jets of hot water and steam. Do not touch the hot parts of the appliance (the steam and water pipes or the area in contact with the filter holder or filter). Do not switch on the appliance with no water in the tank. [. . . ] Fit the lid correctly back onto the water tank again. Fit the filter into the filter holder (fig. Place the desired amount of ground coffee for 2 or 4 cups in the filter (observe the marks on the inside of the filter). Clean any coffee residues from the edge of the filter holder. Do not compress the coffee or exceed the 4cup mark. Fit the filter holder onto the coffee maker in the direction of the arrows and turn it to "OK" position (fig. Plug in the coffee maker and turn the function selector to (fig. The appliance will take a few minutes to reach the correct temperature. When all the water has gone, turn the function selector to "0". Wait for approximately 2 minutes before removing the filter holder from the appliance. to remove the filter holder , turn it in the opposite direction. Hold it by its lever (h) and empty it (fig. Before using the coffee maker for the first time, carefully clean all the removable parts with warm water and detergent (the filter, filter holder and glass carafe with its lid). To clean the inside of the coffee maker, run it twice without any coffee in the filter. Fill the water tank with the amount of water for the desired number of cups of coffee, and add 1 or 11/2 more cups of water to make steam. Fill a tall, narrow container (preferably metal) half-full of very cold low-fat milk. Place the steam pipe (c) in the container, with the steam nozzle (d) submerged about 2 cm in the milk, without touching the bottom of the container. Turn the function selector to a position within the steam adjustment field, between the symbols and (fig. Wait for a few seconds until the steam is expelled. When it has finished frothing up the milk, turn the function selector to "0" (fig. Unplug the appliance and turn the function selector to to expel any steam left in the tank. Clean the steam pipe (c) and the steam nozzle (d) with a damp cloth after each use. [. . . ] Do not use solvents or abrasive products to clean it. do not submerge the appliance in water or place it under the tap. Cleaning the steam nozzle: Clean the outside of the steam pipe with a damp cloth immediately after use. Expel a short jet of steam after each use. [. . . ]