User manual FAGOR VCE-240

[. . . ] Do not leave the appliance unattended when it is turned on because it can be dangerous. When removing the plug never pull on the cable. This product complies with the European Directives on Electromagnetic Compatibility and Low Voltage. Before using this appliance for the first time, read the following instructions carefully and keep them for future reference. [. . . ] If a repair is required, contact a Technical Assistance Service authorised by the manufacturer and request the use of original spare parts. if the cable for this appliance is damaged , contact an authorised Technical Assistance Service for it to be replaced. Do not leave the appliance exposed to the elements (rain, sun, ice, etc. Do not use or let any part of the appliance come into contact or near hot surfaces (kitchen gas or electric hobs or ovens). Do not use detergents or abrasive sponges to clean the appliance. Do not let the cable come into contact with the hot parts of the appliance. Do not vacuum water or any other liquid. Make sure that the on/off switches of the vacuum cleaner and the hand-held vacuum are in the off position before charging. It is advisable to change the dust container filter every three to six months, depending on use, to ensure maximum performance of the appliance. Never use the vacuum cleaner without the container filter. After cleaning the container filter, make sure that it is completely dry before reinstalling it in the vacuum cleaner. To return it to the collapsed position, press the handle release button (2) again and move the handle downwards until it clicks into place. The vacuum cleaner will not operate if the hand-held vacuum is not properly positioned in its receptacle. to start the vacuum cleaner , press the on/off button of the vacuum cleaner (10) or move the on/off switch of the hand-held vacuum (7) to the ON position. To stop the vacuum cleaner, press the on/off button (10) again or move the on/off switch of the hand-held vacuum (7) to the OFF position. HAND-HELD VACUUM: To extract the hand-held vacuum (5) from the appliance, press the hand-held vacuum release button (3) and pull it out as shown in figure D. Once you have extracted the hand-held vacuum, move the on/off switch (7) to the ON position to start it. Move the on/ off switch to the OFF position to stop the hand-held vacuum. To put the hand-held vacuum (5) back into the appliance, firstly place the lower part into the receptacle on the appliance and then push the hand-held vacuum towards the appliance until it clicks into place in the receptacle. Empty the dust container and clean the filter after every use in order to achieve the maximum performance of the appliance. Make sure that the appliance is not connected to the charger before cleaning the dust container. Press the container opening button (8) and pull it out of the container (9). [. . . ] Never use the vacuum cleaner without the filter. CAREFUL: The suction hole must be open and unobstructed at all times; otherwise, the motor may overheat and become damaged. : It is advisable to change the dust container filter every three to six months, depending on use, to ensure maximum performance of the appliance. The contacts between the appliance and the charger base are dirty 3. [. . . ]