User manual FALCON ELAN DELUXE 110 INDUCTION

[. . . ] Installation Service and Spares Dear Installer Safety Requirements Provision of Ventilation Location of Cooker Positioning the Cooker Moving the Cooker Completing the Move Levelling Electrical Connection Repositioning the Cooker following Connection Hob Check Grill Check Oven Check Fitting the Handles and Handrail (Classic model only) 22 22 23 23 23 23 24 25 25 25 26 27 27 27 27 27 28 28 28 2. cooker Overview The Hob The Grill / Glide-out Grill The Ovens The Clock Accessories Main Oven Light 4 4 6 7 8 12 12 3. Cooking Tips Hints on Using your Induction Cooker Tips on Cooking with the Timer General Oven Tips 13 13 13 13 Fitting the Plinth Fitting the Splashback (Classic model only) Customer Care 4. Troubleshooting 19 Due to our policy of continual improvement, we reserve the right to change specifications without prior notice. [. . . ] Lift the grill pan clear of the support frame. The support frame is held to the side rails by two clips on each side (Fig. For each side, support the side rail with one hand and with the other hand lift the frame up and out of the side clips (Fig. For safety, push the side rails back into the grill chamber. If you need to remove the side rails to allow cleaning of the grill chamber, you can unhook them from the grill chamber sides (Fig. 5-5) and wipe the sides clean with a soft cloth and mild detergent. dO nn NOT put the side runners in a dishwasher. Once you have finished, hook the side rails back onto the sides of the chamber. To refit the frame, pull the side rails forward and, for each side in turn, support the side rail and press the frame down into the side rails. When refitting the grill pan, ensure that the wide rim is at the front (Fig. 5-5 Avoid using any abrasive cleaners, including cream cleaners, on brushed stainless steel surfaces. For best results, use a liquid detergent or multi-purpose cleaner. The same cleaner can also be used on the doors. Alternatively, use a soft cloth wrung out in clean hot soapy water. You can use the same method for cleaning the control panel and knobs. After cleaning, polish with a dry cloth. Com manuals search engine Glass Door Panels (some models) The oven door front panels can be taken off so that the glass panels can be cleaned. Move the cooker forward to gain access to the sides (see the ‘Moving the Cooker’ section under ‘Installation’). Open the oven door slightly and remove the front panel fixing screws from the door sides, two each side (Fig. Carefully lift off the outer door panel. The inside face of the glass panels can now be cleaned – take care not to disturb or wet the door insulation. Note: If the door is triple glazed then the inner two panels are fixed together and should not be separated. [. . . ] If it is not possible to disconnect the leads in this way, pull the cooker forward to gain access to the rear. Remove the screws securing the electric cover to the back sheet, remove the cover and disconnect the terminals from the rear. Pull the cooker forward to gain access to the rear. Remove the screws securing the electric cover to the back sheet and remove the cover. [. . . ]