User manual FALMEC ALTAIR INSTALLATION SHEET

[. . . ] These warnings have been provided for the your safety and the safety of others. As a result, please read them carefully before installing and operating the appliance. This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely. Young children should be supervised to ensure they do not play with the appliance. [. . . ] Check that the charcoal filters are fitted to the motor, and if not, install them as described in the instructions in point H. if the hood is of filtering type , remove the non-return valve fitted at the motor's outlet. For maximum efficiency, the third speed should be used when there are strong odours or a lot of steam, the second speed in normal conditions, and the first speed for keeping the air clean with minimum energy consumption. The range hood should be switched on when starting to cook, and left on until the odours disappear. SPEED - Switch B This is used to start and set the speed of the motor, from 1 to 3, or with continuous speed variator, depending on the version. LIGHT- button Pressed: the light is on Released: the light is off MOTOR button - 1, 2, 3, OFF 1: starts the motor at minimum speed 2: starts the motor at medium speed 3: starts the motor at maximum speed OFF: stops the motor OFF: light off; Pushbutton Press to reduce motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). Pushbutton + Press to increase motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). After 15 minutes the motor returns to the third speed). mode pushbutton Function: it turns hood motor on and off. The function "desired speed" enables to start the motor at the speed that was selected before the hood was last turned off. optional: version with remote control (some versions only). B) Remove, by levering with a screwdriver, the support ring A for the cover glass. C) Remove the cover glass B to access the light compartment. d) Replace the lamp with the same type (halogen , max 20 W , 12 Volt , G4 fitting). E) Replace the glass cover B and fasten it using the special ring A. Round halogen light How to replace the dicroic lamp: a) Check that the equipment is disconnected from the power supply. B) Remove the lamp with the help of a screwdriver (see figure) c) Replace the lamp with a similar one (dichroic, max 20 W, 12 Volt). Dicroic spot How to replace a square halogen light: a) Check that the equipment is disconnected from the power supply. B) Open the panel completely till 90° (see figure) pressing the PUSH button c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection). If the panel does not close correctly repeat the operation at point b. Square halogen light (Section reserved for qualified installers) Replacing the fluorescent tube: a) Disconnect the device from the mains; b) Unscrew the fixing screws and remove the bottom panel; c) Remove the fluorescent tube, by rotating through 90°, and replace it with one of similar features (8W-13W-21W-28W according with the model); d) Reconnect the device to the mains. Special attention should be paid to the metal grease-trapping filters and the charcoal filters. [. . . ] The electrical parts or parts of the motor assembly inside the range hood must not be cleaned using liquids or solvents. All the above operations must be performed after having disconnected the appliance from the mains power supply. The electrical system features an earth connection in compliance with international safety standards; furthermore, it is compliant with the European standard for electromagnetic compatibility. Sure the mains voltage corresponds to the values on the rating plate located inside the range hood. [. . . ]