User manual FALMEC ALTAIR TOP INSTALLATION SHEET

[. . . ] These warnings have been provided for the your safety and the safety of others. As a result, please read them carefully before installing and operating the appliance. This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely. Young children should be supervised to ensure they do not play with the appliance. [. . . ] The range hood is used at the same time as appliances burning gas or other fuels, according to the standard. Deviation for Germany: When the range hood and appliances supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4x10 E-5 bar). In this version, the air passes through charcoal filters for purification, and is then recirculated back into the kitchen. Check that the charcoal filters are fitted to the motor, and if not, install them as described in the instructions in point H. if the hood is of filtering type , remove the non-return valve fitted at the motor's outlet. For maximum efficiency, the third speed should be used when there are strong odours or a lot of steam, the second speed in normal conditions, and the first speed for keeping the air clean with minimum energy consumption. The range hood should be switched on when starting to cook, and left on until the odours disappear. SPEED - Switch B This is used to start and set the speed of the motor, from 1 to 3, or with continuous speed variator, depending on the version. LIGHT- button Pressed: the light is on Released: the light is off MOTOR button - 1, 2, 3, OFF 1: starts the motor at minimum speed 2: starts the motor at medium speed 3: starts the motor at maximum speed OFF: stops the motor OFF: light off; Pushbutton Press to reduce motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). Pushbutton + Press to increase motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). After 15 minutes the motor returns to the third speed). Unscrew the support screw A and remove the light cover. Replace the light bulb with the same model as the original (max 25 W, see the markings near the light). Light bulbs with different shapes and power ratings from the original may seriously damage the light compartment. To replace the lamp for "Round halogen light": a) Make sure the appliance is disconnected from the mains power supply. B) Remove, by levering with a screwdriver, the support ring A for the cover glass. C) Remove the cover glass B to access the light compartment. d) Replace the lamp with the same type (halogen , max 20 W , 12 Volt , G4 fitting). E) Replace the glass cover B and fasten it using the special ring A. Round halogen light How to replace the dicroic lamp: a) Check that the equipment is disconnected from the power supply. B) Remove the lamp with the help of a screwdriver (see figure) c) Replace the lamp with a similar one (dichroic, max 20 W, 12 Volt). Dicroic spot How to replace a square halogen light: a) Check that the equipment is disconnected from the power supply. [. . . ] In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using abrasive substances or rough cloths will inevitably damage the finish of steel. the steel surface will be irrevocably damaged if the instructions above are not complied with. [. . . ]