User manual FALMEC FUTURA ANGOLO

[. . . ] La presente garanzia è valida solo per l'Italia (Guarantee conditions are valid only for Italy). Installation operations are to be carried out by skilled and qualiied installers in accordance with the instructions in this booklet and in compliance with the regulations in force. DO NOT use the hood if the power supply cable or other components are damaged: disconnect the hood from the electrical power supply and contact the Dealer or an authorised Servicing Dealer for repairs. Do not modify the electrical, mechanical or functional structure of the equipment. [. . . ] If other appliances that use gas or other fuels are being used at the same time (boiler, stove, ireplaces, etc. ), make sure the room where the fumes are discharged is well-ventilated, in compliance with the local regulations. iNSTALLATION Only intended for qualiied personnel Before installing the hood, carefully read the chapter 'SAFETY INSTRUCTIONS AND WARNINGS'. tECHNICAL FEATURES The technical speciications are exhibited on the labels located inside the hood. pOSITIONING The minimum distance between the highest part of the cooking equipment and the lowest part of the hood is indicated in the installation instructions. Generally, when the hood is placed over gas cookers, the distance must be at least 65 cm (25. However, according to an interpretation of standard EN60335-2-31 dated 11-072002 of TC61 (sub-clause 7. 11), the minimum distance between the cooker and lower part of the hood can be reduced to the quota reported in the installation instructions. Should the instructions for the gas cooker specify a greater distance, this must be taken into consideration. Do not install the hood outdoors and do not expose it to outdoor environment (rain, wind, etc. Disconnect the equipment from electrical mains power supply before carrying out any operations on the hood. Ensure that the wires inside the hood are not disconnected or cut: in the event of damage, contact your nearest Servicing Department. refer to qualiied personnel for electrical connections. Connection must be carried out in compliance with the provisions of law in force. Before connecting the hood to the electrical mains power supply, check that: voltage supply corresponds with what is reported on the data plate located inside the hood; the electrical system is compliant and can withstand the load (see the technical speciications located inside the hood); the power supply plug and cable do not come into contact with temperatures exceeding 70 °C; the power supply system is efectively and properly connected to earth in compliance with regulations in force; the socket used to connect the hood is within reach. In case of: devices itted with cables without a plug: the type of plug to use is a ''standardised'' one. The wires must be connected as follows: yellow-green for earthing, blue for neutral and brown for the phase. The plug must be connected to an adequate safety socket. Ixed equipment not provided with a power supply cable and plug, or any other device that ensures disconnection from the electrical mains, with an opening gap of the contacts that enables total disconnection in overvoltage category III conditions. Said disconnection devices must be provided in the mains power supply in compliance with installation regulations. The yellow/green earth cable must not be cut of by the switch. The Manufacturer declines all responsibility for failure to comply with the safety regulations. [. . . ] "Waste electrical and electronic equipment'', accordingly it must not be disposed of with regular unsorted waste (i. do not use corrosive , acid or alkaline detergents. Rinse them well and wait for them to be completely dry before reassembling them. Washing in a dishwasher is permitted, however, it may cause the ilter material to darken: to reduce the possibility of this problem from happening, use low-temperature washes (55°C max. [. . . ]