User manual FALMEC ISLAND

[. . . ] Any modifications that may be required to the electrical system for the installation of the range hood must only be made by qualified electricians. It is dangerous to modify or attempt to modify the characteristics of this system. In the event of malfunctions or if repairs are required to the appliance, do not attempt to solve the problems directly. repairs performed by unqualified persons may cause damage. [. . . ] mode pushbutton Function: it turns hood motor on and off. The function "desired speed" enables to start the motor at the speed that was selected before the hood was last turned off. optional: version with remote control (some versions only). WARNING: Install the hood away from sources of electromagnetic waves, as these could affect the correct operation of the electronic system. The maximum operating distance could be less than 5 metres in case of electromagnetic interference by other equipment. Light pushbutton on remote control: light on/off. ­ and + pushbutton: increase/decrease speed (to start the motor press either the + or the ­ pushbutton). timer pushbutton: see instructions below. Instructions for changing the code (only in case of malfunctions caused by interferences): Disconnect the hood from the power supply Remove the cover of the remote control, change the code with the levers. Connect the hood to the power supply and make sure the lights and the motors are off. press the timer pushbutton for 2 seconds. When the red LED of the control panel lights up press any of the buttons on the control panel. Timer and `filter clogged' alarm pushbutton - This function allows the automatic turning off of the hood after running for 15 minutes at the speed previously set (the pushbutton shows a flickering light). - After about 30 hours of running the pushbutton indicates the need for washing the metal filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton for a few seconds until the red light turns off. Then turn the hood off and on again to check that the alarm has disappeared. To remove the metal grease-trapping filter, simply pull the handle A until releasing it from the front guide; then tilt it slightly downwards, and slide it out of the rear guide. The two filters located at the ends of the motor can now be easily accessed. to install the new filters see picture. In case of hood with the motor box the filter is located on the botton part of the motor box. to install the new filters see picture. To order new filters, use the coupon enclosed with this booklet or provided by the distributor. [. . . ] 2) only if the upper lattice-work is not used, or in the case of a false ceiling. Round halogen light Auswechseln der Lampe "Dicroic lamp": a) Sich vergewissern, dass das Gerät nicht an das Stromnetz angeschlossen ist. Square halogen light (partie réservée au personnel qualifié pour le montage de la hotte) Distance minimale: distance entre la surface de support des casseroles sur la table de cuisson et la partie la plus basse de la hotte. Quand la hotte est placée au-dessus d'un appareil à gaz, cette distance doit être d'au moins 65 cm (voir figure C1). [. . . ]