User manual FALMEC LUMEN INSTALLATION SHEET

[. . . ] Using the recycling mode ___________________________________ ?Electrical connection _______________________________________ ?Assembling the hood _______________________________________ 3 / USING YOUR APPLIANCE ?Control panel description ____________________________________ 4 / CARING FOR AND CLEANING YOUR APPLIANCE ? [. . . ] -Your appliance is intended for standard household use. Do not use it for commercial or industrial purposes or for any other purpose than that for which it was designed. -Do not modify or attempt to modify any of the characteristics of this appliance. -Repairs must only be performed by an approved specialist. -Always unplug the hood before cleaning it or performing other maintenance work. -Provide adequate ventilation for the room in the case of simultaneous use of the hood and other appliances powered by an energy source other than electricity. This will prevent the hood from aspirating the combustion gases. dishes under the hood or operate gas rings under the hood without placing cookware on them (the flames sucked up into the hood can damage the appliance). CARE FOR THE ENVIRONMENT ?This appliance?s packing materials are recyclable. Please recycle the packaging and help protect the environment by placing it in the recycling bins provided by your local council. Your appliance also contains various recyclable materials. - Position the drilling template against the wall, use wall plugs and screws suitable for your type of wall. - Screw the attachment strip to the wall. - Fully unscrew screws 2 to withdraw the hook as far as it will go. - Tighten screws 2 up again until the appliance is clamped flat against the wall. - Screw 1 is used to adjust the horizontal positioning of the cooker hood. - Open the door of the hood, remove the cartridge filter, and put the anti-lift screws (3) in place. -Place the carbon filter in the filter cartridge with the 2 metal attachment brackets (see section on changing the carbon filter). -Secure the grid (4) in place with the 2 screws provided. 1 2 1 2 4 3 9 EN 3 / USING YOUR APPLIANCE Eolysis Light Timer Boost Speed 3 Speed 2 On/Off - Speed 1 Tip This Guide to Installation and Use is valid for several models. There may be minor differences between the details and fittings on your appliance and the description provided. 10 3 / USING YOUR APPLIANCE EN CONTROL PANEL DESCRIPTION ?On/Off Pressing the button starts the hood in speed 1 (the button turns the hood off. button is illuminated). A long press on the ? [. . . ] Auto stop lighting If you forget to turn off the light on your hood, it will turn itself off automatically after 9 hours. 12 4 / CARING FOR AND CLEANING YOUR APPLIANCE EN Note Disconnect the appliance by unplugging it or using the circuit breaker before cleaning it or performing other forms of maintenance. Regular maintenance of your appliance is a guarantee of proper functioning, good performance and durability. Failure to respect the guidelines for cleaning the appliance and filters may cause fires. [. . . ]