User manual FALMEC LUMEN ILOT 120

[. . . ] For best results, we suggest that you carefully follow the operating and maintenance instructions provided in this booklet; in addition, to order spare charcoal filters, use the special coupon on the cover. 12 GB INSTRUCTIONS BOOKLET WARNINGS This instruction booklet must be kept together with the appliance for future reference. If the appliance is sold or consigned to other parties, check that the booklet is supplied with it, to ensure that the new user has the correct information on the operation of the range hood and is aware of the warnings. These warnings have been provided for the your safety and the safety of others. [. . . ] The maximum operating distance could be less than 5 metres in case of electromagnetic interference by other equipment. Light pushbutton on remote control: light on/off. € and + pushbutton: increase/decrease speed (to start the motor press either the + or the – pushbutton). timer pushbutton: see instructions below. Timer and ‘filter clogged’ alarm pushbutton - This function allows the automatic turning off of the hood after running for 15 minutes at the speed previously set (the pushbutton shows a flickering light). - After about 30 hours of running the pushbutton indicates the need for washing the metal filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton for a few seconds until the red light turns off. Then turn the hood off and on again to check that the alarm has disappeared. ELECTRONIC CONTROL PANEL 1: Timer/Alarm filters The steady RED light indicates that the fat filter alarm is activated (after 30 hours), to deactivate this alarm and zero the meters, maintain the Key pressed for 3 seconds. Flashing RED light indicates that the timer function is activated. This function can only be activated if the motor is activated and running at any velocity when the Key is pressed (either prolonged or not). This function will cause the automatic switch-off of the hood after 15 minutes. With the Timer function activated, the hood can be switched-off by the operator in any case and the function will be deactivated. 16 The Timer function remains associated to a velocity. A change in the velocity, with the Timer function activated, will deactivate it. 2: 1st Velocity When the LED is switched-off, non-prolonged pressing of the key will switch-on the hood at the 1st velocity and illuminate the respective LED. The function will switch-on when the Key is released. When the LED is switched-off and another velocity is activated, pressing the Key will imply selection of the 1st velocity, switching-on of the respective LED and switching-off of the LED associated with the velocity that was previously selected. When the LED is on, pressing the Key will imply the switching-off the LED and MOTOR. When the LED is switched-off, prolonged pressing (at least 3 seconds) of the Key will cause activation of the recirculation function. During the recirculation function (with a duration of 24 hours), the LED will flash. From the activation of this function, the hood will remain switched-on for one hour at the 1st velocity, after which it will switch-off for 3 hours and then reactivate for another hour. [. . . ] The manufacturer accepts no liability for any damage caused by non-compliance with the instructions above. CLEANING THE INSIDE OF THE APPLIANCE The electrical parts or parts of the motor assembly inside the range hood must not be cleaned using liquids or solvents. All the above operations must be performed after having disconnected the appliance from the mains power supply. M WARRANTY The new equipment is covered by warranty. [. . . ]