User manual FALMEC ONDA1440

[. . . ] For best results, we suggest that you carefully follow the operating and maintenance instructions provided in this booklet; in addition, to order spare charcoal filters, use the special coupon on the cover. Round halogen light Per sostituire la lampada “Dicroic lamp”: a) Accertarsi che l’apparecchio sia scollegato dalla rete elettrica. 13 GB INSTRUCTIONS BOOKLET WARNINGS This instruction booklet must be kept together with the appliance for future reference. If the appliance is sold or consigned to other parties, check that the booklet is supplied with it, to ensure that the new user has the correct information on the operation of the range hood and is aware of the warnings. [. . . ] The function “desired speed” enables to start the motor at the speed that was selected before the hood was last turned off. optional: version with remote control (some versions only). WARNING: Install the hood away from sources of electromagnetic waves, as these could affect the correct operation of the electronic system. The maximum operating distance could be less than 5 metres in case of electromagnetic interference by other equipment. Light pushbutton on remote control: light on/off. 17 – and + pushbutton: increase/decrease speed (to start the motor press either the + or the – pushbutton). timer pushbutton: see instructions below. Timer and ‘filter clogged’ alarm pushbutton • This function allows the automatic turning off of the hood after running for 15 minutes at the speed previously set (the pushbutton shows a flickering light). € After about 30 hours of running the pushbutton indicates the need for washing the metal filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton for a few seconds until the red light turns off. Then turn the hood off and on again to check that the alarm has disappeared. h FILTERS REMOVING AND REPLACING’S INSTRUCTIONS 1. METAL FILTERS To remove the metal grease-trapping filter, simply pull the handle A until releasing it from the front guide; then tilt it slightly downwards, and slide it out of the rear guide. To reposition the filter, repeat the operation in the reverse order. Hoods with perimeter suction: Open the panel (see fig. Use handle A to remove the metal grease filter. CHARCOAL FILTERS To replace the charcoal filters, proceed as follows: remove the metal filters as described above. The two filters located at the ends of the motor can now be easily accessed. To install the new filters see picture. In case of hood with the motor box the filter is located on the botton part of the motor box. To install the new filters see picture. To order new charcoal filters contact the distributor/retailer. [. . . ] O MOUNTING INSTRUCTIONS, RANGE HOODS WITH BOX Step 1 - Rest the support bar against the wall (A-Fig. 1) at a height from the cooktop determined by the sum of the distance X+Y+320 mm. - Check the horizontal alignment with a spirit level and mark the 2 holes to be drilled at the ends of the bar. - Drill the holes , insert 2 x 8mm dia. [. . . ]