User manual FALMEC QUASAR

[. . . ] It is dangerous to modify or attempt to modify the characteristics of this system. In the event of malfunctions or if repairs are required to the appliance, do not attempt to solve the problems directly. repairs performed by unqualified persons may cause damage. For all repair and other work on the appliance, contact an authorised service/spare parts centre. [. . . ] The range hood should be switched on when starting to cook, and left on until the odours disappear. OFF: light off; Pushbutton Press to reduce motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). Pushbutton + Press to increase motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). After 15 minutes the motor returns to the third speed). mode pushbutton Function: it turns hood motor on and off. The function "desired speed" enables to start the motor at the speed that was selected before the hood was last turned off. optional: version with remote control (some versions only). WARNING: Install the hood away from sources of electromagnetic waves, as these could affect the correct operation of the electronic system. The maximum operating distance could be less than 5 metres in case of electromagnetic interference by other equipment. Light pushbutton on remote control: light on/off. ­ and + pushbutton: increase/decrease speed (to start the motor press either the + or the ­ pushbutton). timer pushbutton: see instructions below. Instructions for changing the code (only in case of malfunctions caused by interferences): Disconnect the hood from the power supply Remove the cover of the remote control, change the code with the levers. Connect the hood to the power supply and make sure the lights and the motors are off. press the timer pushbutton for 2 seconds. When the red LED of the control panel lights up press any of the buttons on the control panel. timer and `filter clogged' alarm pushbutton · This function allows the automatic turning off of the hood after running for 15 minutes at the speed previously set (the pushbutton shows a flickering light). ⷠAfter about 30 hours of running the pushbutton indicates the need for washing the metal filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton for a few seconds until the red light turns off. Then turn the hood off and on again to check that the alarm has disappeared. The function "desired speed" enables to start the motor at the speed that was selected before the hood was last turned off. Push-button Press to reduce motor speed Display It indicates the current speed Push-button + Press to increase motor speed Timer This function allows the automatic turning off of the hood after running for 15 minutes at the speed previously set (the display shows a flickering light). [. . . ] - Ensure that all regulations concerning the discharge of exhaust air have been fulfilled before you use the appliance. Before performing any cleaning or maintenance operations, disconnect the appliance by unplugging it or using the main switch. The manufacturer disclaims all liability for any damage that may be directly or indirectly caused to people, things and animals due to the failure to follow all the instructions provided in this booklet and above all the warnings relating to the installation, operation and maintenance of the appliance. The new equipment is covered by warranty. [. . . ]