User manual FALMEC QUASARV1431 & QUASARV1420,MV

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual FALMEC QUASARV1431 & QUASARV1420,MV. We hope that this FALMEC QUASARV1431 & QUASARV1420,MV user guide will be useful to you.

Lastmanuals help download the user guide FALMEC QUASARV1431 & QUASARV1420,MV.


Mode d'emploi FALMEC QUASARV1431 & QUASARV1420,MV
Download
Manual abstract: user guide FALMEC QUASARV1431 & QUASARV1420,MV

Detailed instructions for use are in the User's Guide.

[. . . ] UK - Installation with vertical outlet: Measurements for installation (1). UK - Installation with rear outlet: Measurements for installation (5). La presente garanzia è valida solo per l’Italia (Guarantee conditions are valid only for Italy). Rivenditore: Città: Data d’acquisto: 14 SAFETy INSTRUCTIONS AND wARNINGS Installation operations are to be carried out by skilled and qualiied installers in accordance with the instructions in this booklet and in compliance with the regulations in force. [. . . ] Should the instructions for the gas cooker specify a greater distance, this must be taken into consideration. Do not install the hood outdoors and do not expose it to outdoor environment (rain, wind, etc. USER wARNINGS These warnings have been drawn up for your personal safety and those of others. You are therefore kindly asked to read the booklet carefully in its entirety before using the or cleaning the equipment. The Manufacturer declines all responsibility for any damage caused directly, or indirectly, to persons, things and pets as a consequence of failing to comply with the safety warnings indicated in this booklet. It is imperative that this instructions booklet is kept together with the equipment for any future consultation. 15 ENGLISH ELECTRICAL CONNECTION (only intended for qualiied personnel) Disconnect the equipment from electrical mains power supply before carrying out any operations on the hood. Ensure that the wires inside the hood are not disconnected or cut: in the event of damage, contact your nearest Servicing Department. refer to qualiied personnel for electrical connections. Connection must be carried out in compliance with the provisions of law in force. Before connecting the hood to the electrical mains power supply, check that: • voltage supply corresponds with what is reported on the data plate located inside the hood; • the electrical system is compliant and can withstand the load (see the technical speciications located inside the hood); • the power supply plug and cable do not come into contact with temperatures exceeding 70 °C; • the power supply system is efectively and properly connected to earth in compliance with regulations in force; • the socket used to connect the hood is within reach. In case of: • devices itted with cables without a plugн the type of plug to use is a ''standardised'' oneв The wires must be connected as follows: yellow-green for earthing, blue for neutral and brown for the phase. The plug must be connected to an adequate safety socket. € ixed equipment not provided with a power supply cable and plug, or any other device that ensures disconnection from the electrical mains, with an opening gap of the contacts that enables total disconnection in overvoltage category III conditions. Said disconnection devices must be provided in the mains power supply in compliance with installation regulations. The yellow/green earth cable must not be cut of by the switch. The Manufacturer declines all responsibility for failure to comply with the safety regulations. 1st speed: maintains the air clean with low electricity consumption. The metal ilters must be cleaned every 30 hours of operation. The active carbon ilters must be replaced every 3-4 months, depending on the use of the hood. ELECTRONIC PUSHBUTTON PANEL (TOP, TOP A+) Motor ON/OFF Upon start-up, the speed is that stored at the previous operation. The speeds are indicated by the LEDs on the keys: Increase speed from 1 to 4 Speed 4 is only active for a few minutes, then speed 3 activates. [. . . ] To extract and insert the metal anti-grease ilters see the assembly instructions. INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES The EU WEEE Directive was implemented diferently in each country, accordingly, if you wish to dispose of this appliance we suggest contacting your local authorities or dealer to ind out what the correct method of disposal is. INFORMATION ON DISPOSAL IN NON-EUROPEAN UNION COUNTRIES The crossed-out trash or refuse bin symbol is only valid in the European Union: if you wish to dispose of this appliance in other countries, we suggest contacting your local authorities or dealer to ind out what the correct method of disposal is. ACTIVE CARBON FILTERS These ilters retain the odours in the air that passes through them. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE FALMEC QUASARV1431 & QUASARV1420,MV

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual FALMEC QUASARV1431 & QUASARV1420,MV will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag