User manual FALMEC VIRGOLA3230

[. . . ] Assembly of the duct cover and electrical connections (6). La presente garanzia è valida solo per l’Italia (Guarantee conditions are valid only for Italy). Rivenditore: Città: Data d’acquisto: 11 ITALIANO GARANZIA (solo per l'Italia) CONDIZIONI DI GARANZIA SAFETY INSTRUCTIONS AND WARNINGS Installation operations are to be carried out by skilled and qualiied installers in accordance with the instructions in this booklet and in compliance with the regulations in force. DO NOT use the hood if the power supply cable or other components are damaged: disconnect the hood from the electrical power supply and contact the Dealer or an authorised Servicing Dealer for repairs. [. . . ] USER WARNINGS These warnings have been drawn up for your personal safety and those of others. You are therefore kindly asked to read the booklet carefully in its entirety before using the or cleaning the equipment. The Manufacturer declines all responsibility for any damage caused directly, or indirectly, to persons, things and pets as a consequence of failing to comply with the safety warnings indicated in this booklet. It is imperative that this instructions booklet is kept together with the equipment for any future consultation. 12 ELECTRICAL CONNECTION (only intended for qualiied personnel) Disconnect the equipment from electrical mains power supply before carrying out any operations on the hood. Ensure that the wires inside the hood are not disconnected or cut: in the event of damage, contact your nearest Servicing Department. refer to qualiied personnel for electrical connections. Connection must be carried out in compliance with the provisions of law in force. Before connecting the hood to the electrical mains power supply, check that: • voltage supply corresponds with what is reported on the data plate located inside the hood; • the electrical system is compliant and can withstand the load (see the technical speciications located inside the hood); • the power supply plug and cable do not come into contact with temperatures exceeding 70 °C; • the power supply system is efectively and properly connected to earth in compliance with regulations in force; • the socket used to connect the hood is within reach. In case of: • devices itted with cables without a plug: the type of plug to use is a ''standardised'' one. The wires must be connected as follows: yellow-green for earthing, blue for neutral and brown for the phase. The plug must be connected to an adequate safety socket. € ixed equipment not provided with a power supply cable and plug, or any other device that ensures disconnection from the electrical mains, with an opening gap of the contacts that enables total disconnection in overvoltage category III conditions. Said disconnection devices must be provided in the mains power supply in compliance with installation regulations. The yellow/green earth cable must not be cut of by the switch. The Manufacturer declines all responsibility for failure to comply with the safety regulations. Switch on the hood at least one minute before starting to cook to direct fumes and vapours towards the suction surface. After cooking, leave the hood operating until complete extraction of all vapours and odours. By means of the Timer function, it is possible to set auto switch-of function which will allow the hood to turn of automatically after 15 minutes of operation. 1st speed: maintains the circulation of clean air with low electricity consumption. The metal ilters must be cleaned every 30 hours of operation. The active carbon ilters must be replaced every 3-4 months, depending on the use of the hood. [. . . ] METAL ANTI-GREASE FILTERS It is advised to frequently wash the metal ilters (at least once a month) leaving them to soak in boiling water and cleaning solution for 1 hour, taking care not to bend them. do not use corrosive , acid or alkaline detergents. Rinse them well and wait for them to be completely dry before reassembling them. Washing in a dishwasher is permitted, however, it may cause the ilter material to darken: to reduce the possibility of this problem from happening, use low-temperature washes (55°C max. [. . . ]