User manual FALMEC WALL

[. . . ] For best results, we suggest that you carefully follow the operating and maintenance instructions provided in this booklet; in addition, to order spare charcoal filters, use the special coupon on the cover. Round halogen light Per sostituire la lampada "Dicroic lamp": a) Accertarsi che l'apparecchio sia scollegato dalla rete elettrica. Square halogen light This instruction booklet must be kept together with the appliance for future reference. If the appliance is sold or consigned to other parties, check that the booklet is supplied with it, to ensure that the new user has the correct information on the operation of the range hood and is aware of the warnings. [. . . ] After 15 minutes the motor returns to the third speed). mode pushbutton Function: it turns hood motor on and off. The function "desired speed" enables to start the motor at the speed that was selected before the hood was last turned off. optional: version with remote control (some versions only). WARNING: Install the hood away from sources of electromagnetic waves, as these could affect the correct operation of the electronic system. The maximum operating distance could be less than 5 metres in case of electromagnetic interference by other equipment. Light pushbutton on remote control: light on/off. ­ and + pushbutton: increase/decrease speed (to start the motor press either the + or the ­ pushbutton). timer pushbutton: see instructions below. Instructions for changing the code (only in case of malfunctions caused by interferences): Disconnect the hood from the power supply. Remove the cover of the remote control, change the code with the levers. Connect the hood to the power supply and make sure the lights and the motors are off. press the timer pushbutton for 2 seconds. When the red LED of the control panel lights up press any of the buttons on the control panel. timer and `filter clogged' alarm pushbutton · This function allows the automatic turning off of the hood after running for 15 minutes at the speed previously set (the pushbutton shows a flickering light). After about 30 hours of running the pushbutton indicates the need for washing the metal filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton for a few seconds until the red light turns off. Then turn the hood off and on again to check that the alarm has disappeared. To remove the metal grease-trapping filter, simply pull the handle A until releasing it from the front guide; then tilt it slightly downwards, and slide it out of the rear guide. The two filters located at the ends of the motor can now be easily accessed. [. . . ] The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid detergent or denatured alcohol. In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using abrasive substances or rough cloths will inevitably damage the finish of steel. [. . . ]