User manual FAURE CHM160W

[. . . ] The following symbols are used in the text: Safety Instructions Warning: Information concerning your personal safety. Important: Information on how to avoid damaging the appliance. Information and practical tips Environmental information 1. These numbers indicate step by step how to use the appliance. These operating instructions contain information on steps you can take yourself to rectify a possible malfunction. [. . . ] The particularly powerful radiant heater elements significantly shorten the amount of time taken for the zones to heat up. · Cleaning: The advantage of the ceramic glass cooking surface is its easy cleaning. The smooth surface is easy to keep clean (see section: "Cleaning and care"). · Residual heat indicator: The residual heat indicator lights up if the cooking zone becomes so hot that there is a risk of burning. 6 Description of the Appliance Cooking zones and control panel Single Cooking Zone 1200W Single Cooking Zone 1800W Control Knobs Single Cooking Zone 1800W Four Residual Heat Indicators (separate for each zone) Single Cooking Zone 1200W Control Knobs for Rear Right Cooking Zone for Rear Left Cooking Zone for Front Right Cooking Zone for Front Left Cooking Zone 7 Before using for the first time Initial Cleaning Wipe the ceramic glass surface with a damp cloth. 1 Important: Do not use any caustic, abrasive cleaners!The surface could be damaged. Operating the hob 3 When a cooking zone is switched on, it may hum briefly. This is a characteristic of all ceramic glass cooking zones and does not impair either the function or the life of the appliance. Control knobs · The heat settings are continuously variable between settings 1-9. 1 = lowest power 9 = highest power 8 Cooking on the Zones 1. Select a high setting for heating up / browning. 2. As soon a steam starts to form or the oil is hot, turn back to the heat setting necessary for further cooking. 3. To stop cooking, turn back to the zero position. 2 Switch off the cooking zone approx. 5-10 minutes before the end of the cooking to save energy by making use of the residual heat 9 Residual heat indicator The ceramic cooking zone is equipped with a residual heat indicator, a control lamp is allocated to each cooking zone. This lights up as soon the corresponding cooking zone is hot and warns against inadvertant contact. 2 1 1 The residual heat indicator only goes out when the cooking zone has cooled down even when the cooking zone is switched Off. You can use the residual heat for melting and keeping food warm. All cleaning agents must be removed with plenty of clean water after cleaning because they can have a caustic effect when the rings are next heated!Do not use any aggressive cleaners such as grill or oven sprays, coarse scourers or abrasive pan cleaners. Clean the ceramic glass surface after each use when it is warm to the touch or cold. This will avoid spillages becoming burnt on. Remove scale and water marks, fat spots and discolouration with a metallic shimmer using a commercially available ceramic glass or stainless steel cleaner. Light Soiling 1. Wipe the ceramic glass surface with a damp cloth and a little washing up liquid. Remnants of cleaner must not be left on the surface. 3. Thoroughly clean the entire ceramic glass cooking surface once a week with a commercially available ceramic glass or stainless steel cleaner. 4. Then wipe the ceramic glass surface using plenty of clean water and rub dry with a clean fluff-free cloth. Stubborn Soiling 1. To remove food that has boiled over or stubborn splashes, use a glass scraper. 2. Place the glass scraper at an angle to the ceramic glass surface. The new appliance may only be installed and connected by a registered specialist. Please observe this instruction, otherwise the warranty will not cover any damage that may occur. Technical Data Appliance dimensions Width Depth Height 572 mm 502 mm 47 mm Worktop cut-out dimensions Width Depth Corner radius 560 mm 490 mm R5 Cooking rings Position Front left Rear left Rear right Front right Connection voltage Maximum connected load power Diameter 180mm 145mm 180mm 145mm Power 1800W 1200W 1800W 1200W 230 V ~ 50Hz 6, 0kW 16 Regulations, Standards, Directives This appliance meets the following standards: · EN 60 335-1 and EN 60 335-2-6 relating to the safety of electrical appliances for household use and similar purposes and · EN 60350, or DIN 44546 / 44547 / 44548 relating to the operating features of electric cookers, hobs, ovens, and grills for household use. [. . . ] The connecting links should be fitted according to the appropriate connection diagram. The earth lead is connected to terminal E. The earth lead must be longer than leads carrying electric current. The cable connections must be made in accordance with regulations and the terminal screws tightened securely. [. . . ]