User manual FAYTECH 8 INCH TOUCH MONITOR

[. . . ] 144 250 500:1 10/15 140:120 12~36 4 <0, 5 -10~ +60 4-wire resistive 1xUSB port, 1xserial port Windows, Linux, Apple > 10 000 000 < 10 3H 20 ~ 150 2x Video (1x back cam view), 1x SVIDEO, 1x VGA, 1x HDMI 2x Audio-In, 1x earphone out 1x USB port 230V, 12V OSD-Menü, Lautsprecher, Fernbedienung, Touchstift Faytech touch displays are produced following the most modern production and test processes. carefully selected components and accurate production ensure reliable operation and long life. Faytech warrants to the original purchaser that each faytech touch display delivered shall be free from defects in material or workmanship at time of shipment, and that each such module delivered will meet the published specifications for a period of 24 months as measured from the date of original shipment. Faytech's obligation under the Warranty contained herein is limited to the repair or replacement of any faytech touch monitor that does not meet the specifications, provided that said product is returned to faytech, transportation charges pre-paid, and provided that upon faytech's examination, the product, when tested within the specified ratings and in accordance with good engineering practice, does not meet the specifications as defined. [. . . ] It's advisable to close all other programs before beginning this installation. Check the box (see the picture on the next page upper left) only if you want to install the PS/2-Driver. Usually for a USB-touch display, you should NOT select this option. The PS/2-Driver works smoothly with a PS / 2 mouse but if you do not have a PS / 2 mouse you should leave this box unchecked to avoid compatibility problems. A calibration will be performed every time your PC starts up if you choose "Every system boot up". If you choose "Next system boot up" a calibration will be performed on the next system reboot. You can carry out a calibration at any time after the TouchKit program is installed. (See "Setting up the faytech Touch software". ) After making your selection on this screen, click "Next". If you plan to use multiple monitors, please choose this box. "Choose Destination Location": Accept the default destination or choose your own then press "Next". The installation will be started automatically with the selected settings. The installation is successfully completed when the following window appears: If the USB controller icon is not showing, please disconnect the USB cable from your PC and connect it again. (If you accepted all the defaults the program may be at "Start ­ Programs ­ Accessories ­ Touchkit ­ Configure Utility". General tab Gives information on whether one or more touch controllers are found and installed. After the initial installation, if no touch controller shows up on this tab, please pull out the USB connector on your PC and connect the device again. If you don't check this box, the touch function will not work!Enable Cursor Stablization: A software filter exists inside the driver to filter some noise to stabilize and smooth the touch points. When activated, the user will experience a more stable cursor. you can adjust the parameter for the Constant Touch Area function. This is a criterion to judge if the most recent touched point is the same as the previously touched point. If the difference between the two points is within this area, it will be recognized as the same touch point and the driver does not generate a new mouse event for this touch point. [. . . ] If there is a pixel error at your display, please contact us for Support. Text is hard to read, picture looks fuzzy: The display image is in the original resolution (see specifications) clear. at higher resolutions the display interpolates. This leads to inaccuracies and picture distortions. [. . . ]