User manual FELLOWES BLUEVOICE

[. . . ] All rights reserved. What is Bluetooth® Wireless Technology? Bluetooth® wireless technology makes it possible to connect consumer electronic devices using a radio link instead of cables to transmit voice and data information. Bluetooth® technology uses a global frequency range to ensure compatible communication with a variety of devices worldwide. SECTION 1: Charging Your Headset The built-in rechargeable Lithium-Polymer Battery typically provides up to 6 hours of talk time or 180 hours of standby time. Your headset will be fully recharged after 4 hours and 80% recharged after 2 hours. · Charge the headset for at least 4 hours before using it · Use only the charger supplied with the headset (Other chargers may damage unit and void the warranty) · Use the table on page 3 as a reference for charging status PLEASE NOTE: If the headset is fully charged and you plug it into the charging adapter, the LED Indicator Light may not light up at all. Contents Overview . [. . . ] PLEASE NOTE: If pairing does not work, wait 90 seconds, reset your phone or device to the beginning of the Bluetooth® pairing process and repeat steps 1-7. Once pairing is complete, your headset will work with your mobile phone any time both units are powered on and in close proximity to each other. To Pair in Headset and/or Hands Free Mode 1. Activate the Bluetooth® function on your mobile phone or other device. Please refer to your phone's owners manual for instructions. Wait until the LED Indicator Light will flash red/green alternately. Once switched on, the device remains pairable for 3 minutes. To force the headset into pairing mode, slide and hold the volume switch up or down for approximately 7 seconds until the LED Indicator Light flashes an alternating green and red. Headset is pairable for 2 minutes when forced into pairing mode. Make sure the headset and your mobile phone are close to each other while pairing. When the headset enters pairing mode, use your Bluetooth® mobile phone to find it. Follow the Bluetooth® pairing/set-up instructions and screen prompts on your phone to pair it with the headset. Please refer to your phone's owners manual or go to www. fellowes. com/bluetooth for links to popular phone manufacturers' websites. When prompted, enter the headset pin code: 0000. If desired, the pin code may be changed. Due to the multi-pairing feature, if a connection failure occurs, the headset will try to connect to the next most frequently used device on its stored list of devices. The LED will indicate when connection succeeds. If the headset cannot find a device with which to connect, it will go into pairing mode. SECTION 4: General Operation Adjusting the Volume To increase volume, slide volume switch upward for each higher volume level. To decrease volume, slide volume switch downward for each lower volume level. There are eight (8) separate volume levels. During volume adjustment, you will hear short high tones getting louder through the earpiece as the volume goes up and softer as the volume goes down. Turning Headset On/Off To Turn the Headset On Press and hold the On/Off switch for 2 seconds. If the headset is already paired to a mobile phone and the phone is turned on, the LED Indicator Light will flash green for 1. 5 seconds and then every 5 seconds while on or in standby mode. If headset is not paired to a phone, it will go into pairing mode. Pairing Profiles The BlueVoiceTM Headset supports both Hands-Free and Headset profiles. [. . . ] To End a Call When you want to end a call, press the Answer/End button once. When the phone is dialing, you can also press the Answer/End button once to cancel the dialing. Guidelines for Safe, Efficient Use Clean earpiece with a damp, soft cloth. Other cleaners may damage headset and void warranty. Keep headset away from extreme temperatures, water, exceptionally humid or dusty environments, open flame or fire. [. . . ]