User manual FELLOWES CC4-2

[. . . ] Do not attempt to shred paper clips or other hard materials (except staples). ¥ Do not place shredder near or over a heat source or water. ¥ Always turn off and unplug unit before moving or cleaning and when not in use. ¥ Do not insert aerosol cleaners into or around the shredder. [. . . ] (See "TROUBLESHOOTING" if red LED is lit. ) NEVER insert hands or fingers into paper entry as serious personal injury may result. Do not exceed recommended sheet capacity (see "Product Usage Guide" on front cover of this manual). Slide paper straight into paper entry until the shredder automatically begins shredding. The shredder automatically stops a few seconds after shredding is complete. Continue shredding as desired to a MAXIMUM shredding time of 5-7 minutes. At this time, the machine MUST be allowed to "cool down" for a MINIMUM of 15 minutes. (See "Cool-Down Cycle" for more information. ) If the shredder jams or shuts off before the maximum shredding time, see "Clearing a Jam" section for further instructions. Move power switch to OFF (O) position when shredding is complete. Unplug power cord from outlet whenever shredder is unattended or not in use. If full, remove shredder head and empty basket contents. Replace shredder head onto basket. Cool-Down Cycle This shredder is protected with a special safety feature which prevents the motor from overheating with extensive use. When shredding is attempted beyond the machine's maximum running time, the shredder will automatically shut off its motor until it has cooled to an acceptable operating level. This is normal and the shredder will return to operation after the cool-down or "off" period. See "Product Usage Guide" on front panel for maximum running time and related cooling "off" time. Clearing a Jam If the shredder sheet capacity is exceeded or paper is not put in straight, a jam may result. See "Product Usage Guide" on front panel for maximum sheet capacity for your shredder. Move the power switch to the REVERSE (R) position. (NOTE: If waste basket is full, empty it before clearing jam. ) The shredder will reverse the paper to clear the jam. If the shredder jams in reverse, move the power switch to AUTO (I) and allow to run for about five seconds. If jam does not clear, move power switch to REVERSE (R) again and allow to run for about five seconds. Repeat this procedure until the jam is cleared. If necessary, use care to grasp the paper carefully and pull out to clear the jam. Once the jam is cleared, move the power switch to AUTO (I) for continued shredding or OFF (O) if shredding is complete. MAINTENANCE Confetti cut shredders require regular (monthly) oiling of the cutting blades to maintain proper operation. [. . . ] This warranty gives you specific legal rights. You may have other legal rights that vary from state to state. For more detail or to obtain service under this warranty, please contact Fellowes Customer Service at 1-800-955-0959, Monday through Friday, 8 AM - 5 PM (Central Standard Time). For specific instructions on obtaining service under this warranty on machines purchased outside the USA, contact the appropriate location listed in the Contact for Service section of this instruction manual. [. . . ]