User manual FELLOWES GALAXY 500

[. . . ] Ensure the machine is on a stable surface. 2. Check waste tray is empty and correctly fitted. The tray can be accessed from the left and right sides. The tray has a `burst feature' that operates when the chip tray is `over-full'. 6 3. [. . . ] The machine is supplied with loose power leads. Select the correct lead for appropriate power supply. 4. Plug the lead into grounded socket outlet. 5 7 5. Switch the machine on (located at the rear of the machine). 6. Ensure the wire closing lever is pushed backwards. W ire Ga la xy 7. Check the green power neon is on. Galaxy W i re 3 ENGLISH BEFORE YOU BIND Galaxy includes two methods of wire comb closure, for all sizes of wire comb diameters between 6 and 14mm. ­ ideal for binding single documents. The moving closing jaw includes an easy to read scale 12mm 1/2" 10mm 3/8" 8mm 5/16" 6mm 1/4" 14mm 9/16" 2­ Selectable lock control. ­ ideal for multiple documents of the same sizes. Set the red STOP bar to the preferred position. Turn the control wheel towards MAX or MIN positions as required. To hide the seam, turn the rear cover backwards. The seam is hidden inside the document. 3. Good closure retains all sheets. 5 CORRECTING A BOUND DOCUMENT Wire binding is a secure binding system. Additional sheets cannot be added unless the document is disassembled and then re-bound. REMOVAL OF WASTE CLIPPINGS The waste tray is located under the machine and is accessed from each side. For best results empty the tray regularly. The tray should be emptied after every 50 operations to ensure no blockages occur. STORAGE Lower the lid. The Galaxy wire binder is designed to be stored horizontally on the desk. TROUBLESHOOTING Problem No Green power neon Red standby neon Cause Machine is not switched on Machine has overloaded when punching Solution Switch on machine at rear next to plug inlet Press the punch button. The machine will withdraw the punches and re-set itself. Continue this process until the punch cycle is complete Revise closure lock setting to suit smaller diameter as required Punch plastic covers with paper sheets. Reduce number of sheets being punched Check waste tray is empty and `burst feature' is closed Adjust edge guide until hole pattern is correct Check waste tray is empty. Check for blockage to paper entry Take stiff cardboard and slide into the paper entry. [. . . ] Reduce number of sheets being punched Check waste tray is empty and `burst feature' is closed Adjust edge guide until hole pattern is correct Check waste tray is empty. Check for blockage to paper entry Take stiff cardboard and slide into the paper entry. Move the cardboard sideways to release any stray clippings into the waste tray Adjust edge guide and test punch scrap sheets until correct Check closure of wire comb. Place into closing mechanism and improve binding closure. [. . . ]