User manual FELLOWES HELIOS 30

[. . . ] DO NOT exceed the machines quoted performance. DO keep the machine away from heat and water sources. DO NOT allow children to use this machine without adult DO turn off the machine after each use. DO unplug the machine when not in use for an extended DO NOT bind sharp or metal objects (eg: staples, paper period. [. . . ] This can be done before and after the binding process. · · · · 5 BEFORE BINDING 1. 2. Ensure the machine is on a stable surface. Check there is enough clear space around the machine to operate safely. Insert the power lead into the power socket (located at the rear of the machine). 3. 4. Plug the machine into an easily accessible main socket. Open and lift the lid by releasing the safety catches on the front of the lid. HOW TO BIND 5. 6. Switch the power on (located at the rear side). To activate the machine, press the `Power-On' button on the control panel. The machine will warm-up, the red LED will flash. The machine will `beep' (3x) and the LED turns green when the machine is ready to bind. Prepare the documents by loading the sheets into the thermal covers. For best results, do not to place too many or too few sheets into the cover. Use the binding thickness scale as a guide. Helios 30 will accept single or multiple documents up to a combined total thickness of 1. 25" (approximately 300 sheets / 20lb). The selected binding cycle is shown with blue LED. Use the timer selection buttons to navigate up or down the scale, if required. Eg: 0. 25" document thickness = setting 1 (up to 60 sheets), 1. 25" document = setting 10 (up to 300 sheets). 9. Pull open the document clamp (Heat-Shield feature), insert the documents into the binding channel. Ensure the binding covers spine touches the heating element. Start the binding cycle by pressing the `Select / OK' button. The blue LED will start flashing and counting down, in sequence. When the cycle is complete, the machine will beep (3x). The machine has an integral cooling tray. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]