User manual FELLOWES T7CM

[. . . ] We hope it meets ­ or even exceeds ­ your expectations. To ensure years of safe, efficient use, please read these few pages about your new shredder. If this manual doesn't answer all your questions or if you wish to comment on this product, we welcome your call or letter. [. . . ] Align slot at the side of the shredder head (A) with tab on the side of the basket (B) and place it onto the basket in this position. Operation For convenience, your shredder is equipped with an automatic-start sensor (C). This means that when the control switch (D) is in the automatic (I) position, the shredder will start running when you put paper into it and stop 1 or 2 seconds after the paper has passed through. Because the sensor cannot tell the difference between paper and other objects, this feature can also be a hazard, especially to children and pets. To avoid accidents, turn off the shredder as soon as you are finished. Unplug shredder if it will not be used for an extended period. To shred: · Plug in shredder with control switch (D) in off (O) position · Slide control switch to automatic (I) position to signal readiness Paper · Feed paper straight into entry (E), until the shredder automatically begins shredding; see Product Profile for limits on paper width, shreddable items, sheet capacity, etc. · Shred for no more than 2 minutes; shredding longer will cause shredder to turn itself off for 4 minutes to cool down. · Slide control switch to off (O) position after cutting has stopped; cutting continues for 1 or 2 seconds after paper has gone through in order to clear shredded paper from cutting cylinders. Credit Cards · Feed one credit card at a time, straight into designated area (F), releasing when shredding begins. Shredder will stop when credit card has passed through the entry. In case of a paper jam, which may occur if the shredder is pushed beyond its specified capabilities, press the control switch to the off (0) position and empty the basket if full. Then: 1) Slide control switch in reverse (R) position and attempt to back paper out of shredder. 2) If shredder jams in reverse mode, slide control switch to automatic (I) position and attempt to continue shredding operation. 3) If shredder jams again, alternate control switch slowly between reverse (R) and automatic (I) positions to attempt to move jammed paper completely through shredder. If you are unable to clear the jam using this method, turn off and unplug the shredder; remove shredder head from the wastebasket and carefully remove any paper extending below the cutting cylinders; empty the wastebasket; reassemble the shredder and repeat jam clearing procedure. Maintenance Regular emptying of the basket is important to ensure the smooth operation of the cutting cylinders. If paper is within 2 inches of shredder head, turn off and unplug the shredder, remove the shredder head and empty the basket. Troubleshooting If you have a problem with your shredder, check the symptoms and remedies below. If you cannot solve the problem this way, contact Fellowes Customer Service. [. . . ] This warranty gives you specific legal rights. You may have other legal rights that vary from this warranty. The duration, terms and conditions of this warranty are valid worldwide, except where different limitations, restrictions or conditions may be required by local law. [. . . ]