User manual FELLOWES TITAN 125

[. . . ] DO ensure the machine is on a stable surface. DO test laminate scrap sheets before final laminations. DO remove staples and other metal articles prior to laminating. DO keep the machine away from heat and water sources. [. . . ] Ensure the pouch is not too large for the item. Please read these instructions before use. · · SAFE TO TOUCH · 5 SETTING UP THE LAMINATOR 1. Place the machine on a stable surface. Ensure enough clear space behind the machine to allow items to pass through freely. Connect the supplied power cord to the machine. 3. 4. Plug the machine into an easily accessible main socket. 2. To fully support pouches and items of different sizes use the adjustable entry guide to center the item before laminating. Place exit tray onto the rear of the machine. STEPS TO LAMINATE 5. 6. Switch the power on (Power switch located at the rear of the machine). Select the `Standby' button on the control panel. and ready LED's will flash for 5 seconds before automatically selecting the 3 Mil. Any setting can be selected at any time as required. Allow the machine to cool before opening. The LED interface allows selection of these functions: - 3, 4, 5, 7, 10 Mil. pouch settings - Manual laminating - Reverse - `Easy-Access' for cleaning and maintenance. The laminator will automatically select the thinnest pouch setting (3 Mil. ) within 5 seconds of power-on unless another setting is selected. During warm-up or cool-down, the selected pouch setting will flash red. When the laminator has reached the chosen setting, the LED will stop flashing and glow red. The machine will sound 2 short alerts. 9. Place item into open pouch. Center the item against the sealed front edge. Use the appropriate pouch size for the item. Place the pouch, sealed edge first into the document entry. Keep the pouch straight and centered within the document entry, not on an angle. Upon exit, the laminated pouch is hot and soft. [. . . ] Do not use solvents or flammable materials to polish the machine. Cleaning sheets (CRC# 53206) can be used with the machine. When the machine is warm, run the sheets through the machine to clean any residue off the rollers. 8 TROUBLESHOOTING Problem No `red' power on LED Ready light does not come on after a long period Pouch does not completely seal the item Possible cause Machine is not switched on Machine is in a hot or humid area Item may be too thick to laminate Thickness setting may be incorrect Thickness setting may be incorrect Pouch is jammed Pouch was used `open end' first Jamming Pouch was not centered on entry Pouch was not straight upon entry Empty pouch was used Pass cleaning sheets (CRC# 53206) through the machine to test and Pouch is damaged after lamination Damaged rollers or adhesive on rollers clean rollers. Select the open machine setting and clean the rollers with Fellowes roller wipes (CRC# 57037). [. . . ]