User manual FENDER HELLECASTERS WILL RAY JAZZ-A-CASTER

[. . . ] VOLUME A - Controls the loudness of CHANNEL A. TREBLE - Adjusts the overall brightness in the A CHANNEL. BASS - Adjusts the level of low frequencies in the A CHANNEL. MID - Adjusts the level of midrange frequencies in the A CHANNEL. G. [. . . ] MID - Adjusts the amount of midrange frequencies through CHANNEL B. M. VOLUME- Controls the loudness of CHANNEL B. SPECIAL NOTE: This control is best adjusted in conjunction with the rear panel IMPEDANCE switch to enable the amplifier to better achieve the cranked-up sound at a lower volume. On the B CHANNEL, with a single Tone-Master enclosure, this switch should be set according to the setting of the B CHANNEL volume knob: for volume settings of 3. 5 and lower, LO would be the appropriate setting. For settings above 7, HI will produce full power and tone. PILOT JEWEL - When this lamp is illuminated the Tone-Master is receiving power. Should this bulb burn out, turn off the power, unscrew the red jewel and replace the lamp with a type T47 light bulb. CAUTION: TO REDUCE THE RISK OF FIRE, REPLACE FUSE WITH SAME TYPE AND RATING RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR AVIS: ATTENTION: SUPERFICIE DE CHASSIS CHAUDE CAUTION: CHASSIS SURFACE HOT WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE IMPEDANCE LO MED HI 360W ATTENTION: FUSE T4A 250V UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE ET CALIBRE CAUTION: RISK OF ELECTRIC SHOCK DO NOT OPEN PARALLEL SPEAKER JACKS 100W 4 min. TOTAL HELLECASTERS WILL RAY JAZZ-A-CASTER REAR PANEL FUNCTIONS A. FUSE - The fuse is in the AC supply of the amplifier and will help to protect the amplifier in the event of an electrical fault or tube failure. If a fuse blows, it should only be replaced by one with the same type and rating. NEVER use a fuse of higher current rating as this could damage the equipment and present a serious safety hazard. FOOTSWITCH JACK - Plug in connection for the footswitch. The footswitch allows remote switching from CHANNEL A to CHANNEL B. The footswitch will override the front panel A/B switch. CHANNEL B EFFECTS RETURN -Transformer-isolated, low-impedance input or "Return" from effects device(s). CHANNEL B EFFECTS SEND - Low-impedance output or "Send" to effects device(s). CHANNEL A EFFECTS RETURN -Transformer-isolated, low-impedance input or "Return" from effects device(s). CHANNEL A EFFECTS SEND - Low-impedance output or "Send" to effects device(s). LINE CORD -(Not Shown) Your amplifier is equipped with a 3-prong grounding type supply cord to reduce the possibility of shock hazard. Be sure to connect it to a grounded receptacle. DO NOT ALTER THE AC PLUG! TUBES The Tone-Master tube complement consists of 4 Fender special design 5881/6L6WGC's (part# 039214), and 3 Fender special design 12AX7A's (part#023572). Fender's special design tubes provide optimum performance in this amplifier. [. . . ] Be careful to not let liquid come in contact with operating surfaces. TROUBLESHOOTER'S CHECKLIST If the amp is set up but does not function, check the following items: -Is the amp power cord properly plugged into an electrical outlet?-is the speaker(s) properly connected to the amplifier?-Are the amplifier VOLUME, TREBLE, MID and BASS controls above 0? [. . . ]