User manual FENDER KEYBOARD 200 SFX

[. . . ] Built with care and special attention to detail, your SFX Keyboard 200 offers much more than meets the eye. Your SFX Keyboard 200 Amplifier includes among its many features: the Stereo Field eXpansion effect (patent pending) creating unique spatial characteristics via the forward and side-radiating speakers, 80 Watts of power per channel with full time Delta CompTM and On-board DSP. The three channel preamp (2 stereo and 1 mono/mic) with their individual tone controls are voiced for stereo electronic keyboards and microphones. Moreover, the front panel also features insert jacks designed for use with signal processing devices or other line level outboard gear. [. . . ] A special "Y" line cord (stereo to dual mono) is required to use these jacks. The tip is the send and the ring is the return. This three pin XLR balanced female input connector is intended for input signals from low impedance microphones and has a +20 dB gain. LINE - This is a 1/4 inch TRS balanced input jack suited for use with items having a line level output such as high impedance microphones, drum machines, etc. It accepts both balanced and unbalanced cables. 4 P. VOLUME - Adjusts the loudness of the SFX Keyboard 200's mono channel. LOW - Adjusts the amount of increase or decrease in the low frequency range of the SFX Keyboard 200's mono channel. MID - Adjusts the amount of increase or decrease in the middle frequency range of the SFX Keyboard 200's mono channel . HIGH - Adjusts the amount of increase or decrease in the high frequency range of the SFX Keyboard 200's mono channel. DSP SEND - Adjusts the amount of signal from the SFX Keyboard 200's mono channel sent to the on-board DSP. INSERT - 1/4 inch TRS input / output phone jack designed for use with signal processing devices or other line level outboard gear for the mono channel ONLY. A special "Y" line cord (stereo to dual mono) is required to use this jack. The tip is the send and the ring is the return. VOLUME - Adjusts the overall loudness of the SFX Keyboard 200 amplifier. DSP - Adjusts the amount of return signal from the SFX Keyboard 200's on-board DSP. X. SFX - Adjusts the amount of Stereo Field eXpansion effect produced by your SFX Keyboard 200 amplifier. Rotating the knob clockwise increases the SFX spatial effect. Likewise, rotating the knob counterclockwise allows the SFX Keyboard 200 to be used as a traditional amp. [. . . ] Are the DSP control knobs turned above 1?Is the instrument / microphone properly plugged into the amplifier? Jack LINE INPUTS MIC INPUT INSERTS Style 1/4" TRS XLR Female 1/4" TRS 1/4" TRS Connection Balanced Input Balanced Input Input / Output Balanced Output Pin Out Tip = POS Ring = NEG Sleeve = GND Pin 1 = GND Pin 2 = POS Pin 3 = NEG Tip = Send Ring = Return Sleeve = GND Tip = POS Ring = NEG Sleeve = GND Tip = POS Ring = NEG Sleeve = GND LINE OUTPUTS SUB LINE OUT 1/4" TRS Balanced Output (Eliminate any effects pedals and try using another cord. ) If after checking all of the above your amplifier is still not performing correctly, consult your nearest authorized Fender Service Center. COVERING CARE Your SFX Keyboard 200 is covered in a tough, soil resistant synthetic indoor/outdoor carpet for long life and lasting good looks. To clean the carpeted cabinet, use a brush and vacuum to wipe away any smudges or dirt. For stubborn stains, a sponge with a light soapy solution may be used. [. . . ]