User manual FENDER KXR 100

[. . . ] The EFFECTS SEND and EFFECTS RETURN jacks can be used with a wide variety of effects devices, or as patch points for slaving multiple amps together. The EFFECTS SEND can also be used to connect your KXR 100 directly to a recording console or sound reinforcement mixer. The HEADPHONE jack automatically mutes the speaker while driving stereo or mono headphones for private practice sessions. [. . . ] All three channels may be used simultaneously, however Channel 1 should be used first if only one input is needed. Equalizer- The equalizer allows precise adjustments of the tonal characteristics of the amplifier. Each control provides a 12 dB boost or cut to bands of frequencies centered about 100, 338, 1588, and 4000 Hz. Reverb control- This control adjusts the amount of reverb to be mixed with the dry signal. The input to the reverb circuitry is the sum of channels 1, 2 and 3. Effects Send jack- This jack provides an unbalanced output signal from the preamp. This output can be used with the Effects Return jack (item H) as a patch point for mono effects devices. The Effects Send is connected to the input of the effect (digital delay or other effects device) and the output of the effect is connected to the Effects Return jack (item H). The Effects Send can also be used to provide a signal to a recording or sound reinforcement mixer. In addition, this output can be used to drive another KXR 100 as a slave amp. This is done by connecting a standard guitar cord from the Effects Send jack of the master amp to the Effects Return jack of the slave amp. Effects Return jack- This balanced jack inputs signal to the Master Volume control, which drives the power amp section. It automatically disconnects the preamp when used. This jack is useful with the effects loop feature, or when using the KXR 100 as a slave amp. Master Volume control- This control adjusts the level of the signal coming out of the preamplifier section. This control is used in conjunction with the Channel Volume controls to set the overall sound level of the amplifier. In order to maximize headroom and minimize noise, instruments with low-level output will require a high Channel Volume setting and a low Master Volume setting, while other instruments may require a lower Channel Volume and higher Master Volume setting. It is recommended that the Master Volume control be set as high as possible for maximum DELTACOMP' compressor range. [. . . ] (Eliminate any effect pedals and try another guitar cord. ) If, after checking all of the above, the system is still not performing correctly, consult your FENDER Service Dealer. KXR 100 Specifications Part Number: 120V Version: 230V Version: PR 262 100V 120V 230V 240V Version: Version: Version: Version: 100VAC, 120VAC, 230VAC, 240VAC, 50/60 Hz, 360W Max. 22-8501 22-8561 Type Specification: Power Requirements: POWER AMPLIFIER SECTION: Power output: Rated load impedance: Distortion at 80 watts: 80 watts R. M. S. 4 Ohms Less than . 1% @ 1kHz, before compression. [. . . ]