User manual FENDER KXR 60

[. . . ] The Effects Send can also be used to connect your KXR 60 directly to a recording console or sound reinThat is why we proudly say. . . Fender®, The Sound That Creates Legends. years of quality performance and a wide range of musical sounds. [. . . ] The input to the reverb assembly is the sum of Channels 1 and 2. EFFECTS SEND JACK- This jack provides an unbalanced output signal from the preamp. This output can be used with the Effects Return jack (item G) as a patch point for mono effects devices. The Effects Send is connected to the input of the effect (digital delay or other effects device) and the output of the effect is connected to the Effects Return jack (Item G). The Effects Send can also be used to provide a signal to a recording or sound reinforcement mixer. In addition, this output can be used to drive another KXR 60 used as a slave amp. This is done by connecting a standard guitar cord from the Effects Send jack of the master amp to the Effects Return jack of the slave amp. E. F. C. G. EFFECTS RETURN JACK- This balanced jack inputs signal to the Master Volume control which drives the power amp section. It automatically disconnects the preamp when used. This jack is useful with the effects loop feature, or when using the KXR 60 as a slave amp. MASTER VOLUME CONTROL- This control adjusts the level of the signal coming out of the preamplifier section. This control is used in conjunction with the Channel Volume control to set the overall sound level of the amplifier. In order to maximize headroom and minimize noise, instruments with low-level output will require a high Channel Volume setting and a low Master Volume setting, while other instruments will require a lower Channel Volume and higher Master Volume setting. It is recommended that the Master Volume control be set as high as possible for maximum DELTACOMPTM compressor range. TAPE IN JACK- Two RCA style jacks provide an input for an unbalanced, mono signal from a tape player or CD player. This signal is summed with the signal from the preamp inputs and provides the user the ability to play along with pre-recorded music. J. HEADPHONE JACK- This jack allows the use of stereo headphones for private listening. [. . . ] · If you are using an electronic keyboard, does it have power?(Eliminate any effect pedals and try another instrument cord. ) If after checking all of the above, and the system is still not performing correctly, consult your FENDER Service Dealer. ® KXR 60 BLOCK DIAGRAM KXR 60 SPECIFICATIONS Part Number: 120V Version: Aust. Version: UK Version: 230V Version: 100V Version: PR 299 100V Version: 120V Version: 230V Version: 240V Version: 100VAC, 50/60Hz, 180W 120VAC, 60Hz, 180W 230VAC, 50Hz, 180W 240VAC, 50Hz, 180W 022-8500-000 022-8530-000 022-8540-000 022-8560-000 022-8570-000 THIS EQUIPMENT CONFORMS TO THE FOLLOWING DIRECTIVES : EMC 89/336/EEC AND LV 73/23/EEC Type Specification: Power Requirements: POWER AMPLIFIER SECTION: Power output: Rated load impedance: Distortion at 50 watts: 50 W R. M. S. [. . . ]