User manual FENDER MALIBU

[. . . ] High output pickups with the instrument tone control turned down can achieve reverse envelope, backwards tape effects and many other sounds. ) The extended range three band equalization circuitry is post overdrive and can be used to further modify the overall sound of the amp. In addition to convenience features like All Front Panel Mounted Controls and Jacks, the PRINCETON CHORUS features a detachable footswitch for selecting the Overdrive Mode and for activating the stereo chorus circuitry. These functions are multiplexed over a standard 1/4 inch phone plug for ease of connection or extension of the footswitch to remote pedal boards. The versatility of the PRINCETON CHORUS is greatly expanded by the individual mono and true stereo EFFECTS LOOPS. [. . . ] This control works in conjunction with the N. OVERDRIVE-VOLUME control to set the overall loudness at the output. MID-BOOST-Activates a special pre-emphasis filter which accentuates mid-range frequencies. LIMITER-Adjusts the amount of compression at high GAIN settings. The compression is activated by distortion in the preamp, therefore it is not as noticeable at low gain settings. OVERDRIVE INDICATOR-This LED is illuminated when in the overdrive mode. PRESENCE -Adjusts the amount of boost or cut in the upper high frequency range while in the OVERDRIVE mode. This control occurs post preamp distortion and is useful in adjusting the distortion characteristic from brash, to smooth. NOTE: This switch disables the Channel Select Footswitch and the C. VOLUME-Adjusts the overall loudness while in the OVERDRIVE mode. RATE-Adjusts the sweep rate of the chorus generating circuitry. The REVERB & CHORUS are active in the slave so that a stereo image will be generated if the chorus is used. NOTE: In order to function properly, a dummy plug or an extra guitar cord must be inserted into B. INPUT 2 of the slave amp with its VOLUME controls turned down. EFFECTS LOOP STEREO SEND-This jack provides an unbalanced stereo output from the preamp, reverb and chorus circuits of the PRINCETON CHORUS. This output can be used in conjunction with the W. STEREO RETURN as a patch point for stereo effects devices. (SEE: EFFECTS LOOP CONNECTION DIAGRAMS). The Stereo Effects Loop jacks are standard 1/4 inch Tip-Ring-Sleeve types, with the left channel signal on the tip and the right channel signal on the ring. This send can also be used to feed a stereo signal to two channels of a recording or sound reinforcement mixer. Additionally this output can be used to drive another PRINCETON CHORUS as a slave amp. This is done by connecting a shielded stereo cord from the STEREO SEND jack of the master amplifier to the STEREO RETURN of the slave. [. . . ] -Are the speakers properly connected to the amplifier?-Are all the control knobs turned up above four?-Is the volume control on the instrument turned up?-Is your instrument properly plugged into the amplifier? [. . . ]