User manual FENDER PALOMINO

[. . . ] It is an integral part of the audio chain and should be treated with special care and attention to detail. At Fender, we know what building quality musical instruments and sound reinforcement equipment is all about. In fact, many of the world's best sounding electric musical instruments and sound reinforcement equipment proudly wear the Fender name. Whether you need a simple box top powered mixer for your Saturday afternoon jam, or a professional full-size concert system, Fender has the sound reinforcement equipment to meet your needs. [. . . ] Rotating the knob clockwise increases the tape/effects signal sent to the monitor mix. TAPE/EFFECTS RETURN TO MAIN - Adjusts the tape/effects signal level sent to the main mix from either the Effects In or Tape In jacks. Rotating the knob clockwise increases the tape/effects signal sent to the main mix. MAIN - The main output volume control of the SRM 6302 / 8302. Any adjustments to this control will affect the signal level at the Main Out, as well as, PA1 and PA2 depending upon the PA2 Assign switch position and patch bay configuration. 5 I. REVERB RETURN TO MONITOR - Adjusts the amount of reverb signal level sent to the monitor mix. Rotating the knob clockwise increases the reverb signal sent to the monitor mix. When the knob is set at 0, the output is "dry". REVERB RETURN TO MAIN - Adjusts the amount of reverb signal level sent to the main mix. Rotating the knob clockwise increases the reverb signal sent to the main mix. When the knob is set at 0, the output is "dry". Be sure to connect the cord to a grounded receptacle. DO NOT ALTER THE AC PLUG. OFF 6 SPEAKER WIRING AND CONNECTIONS Parallel or series are the two basic ways which multiple speakers can be connected to a single power amplifier. When speakers are connected in parallel, their combined impedance decreases. For speakers wired in series the opposite is true, their combined impedance increases. Also, when speakers are wired in series, higher impedance speakers in the series draw more power from the amplifier than do speakers in the series with lower impedances. When speakers are wired in parallel, the opposite is true. At Fender ®, we recommend connecting multiple speakers in parallel for several reasons. First, if one speaker fails, the others will continue to operate. Second, because in a series connection one speaker affects the output of the other speakers, unpredictable frequency response is a concern. Third, most speaker cabinets are already wired for parallel connections making parallel connections the most common wiring method. When using your SRM 6302 / 8302, be sure that the minimum load connected to each channel is 4 ohms. [. . . ] Connect a microphone to a Mic input jack and any keyboard or other instrument to a Line input jack. Next, connect speaker cords from the PA 1 Out jacks to the main speakers and from the PA 2 Out jacks to the monitor speakers. 3. The level control in each channel strip adjusts the amount of signal sent to the main bus where all channel signals are summed. The Main control in the master section adjusts the volume level to the main speakers. [. . . ]