User manual FENDER PCN-2

[. . . ] No user serviceable parts inside, refer servicing to qualified personnel only. Service by persons other than Fender authorized service technicians may void the warranty. Jewelry and Metal Objects/Materials Exercise care when operating or connecting a battery. Never allow loose jewelry, rings, chains or other conductive materials to come into contact with the battery terminals. Remove rings when using wrenches to work in proximity to any battery power source. SETTING UP THE DC/DC CONVERTER Set up your Passport System in the normal way taking care to follow all of the usual procedures for safety and optimum performance. [. . . ] Remove rings when using wrenches to work in proximity to any battery power source. SETTING UP THE DC/DC CONVERTER Set up your Passport System in the normal way taking care to follow all of the usual procedures for safety and optimum performance. The cable lengths on the DC/DC converter are the maximum recommended. Place the DC/DC Converter near the battery and move the Passport as far away from the battery as the cables will allow. Be sure to place the DC/DC Converter out of direct sunlight in an open but shaded location. Make sure the On / Off switch on both the DC/DC Converter and the Passport are in the Off position. 1) Connect the DC/DC Converter's 4 pin Molex 48volt DC/DC plug into the connector located on rear of the Passport Tower. 2) Next, place the DC/DC Converter to allow clear air flow over the heat sink fins. Also, make sure the DC/DC Converter's On / Off switch is in the Off position. 3) Take a minute to ensure you have clearly identified the respective Positive and Negative terminals of the battery. These may be color coded RED (positive) and BLACK (negative) or simply identified by + and - marks. For an outdoor sporting event with periodic announcements, a fully charged, stand alone 48 amp/ hour battery may provide 12 to 18 hours of use. Remember, these are estimates only and your specific circumstances will vary battery life significantly. For your first event, you may want to take a back up battery using your primary battery until the event ends or the battery charge is depleted. Be sure to note the battery life used for future reference. PASSPORT / PASSPORT 150 TOWER FUSE INSTALLATION Your DC/DC Converter is supplied with two (2) 10 amp fuses. These fuses must be installed into your Passport System Power Tower, before any attempt at operating the DC/DC Converter with a Passport system. Caution: Make sure all connections are removed from the Tower. 1) Passport: Carefully place the Passport tower mixer side down on a hard surface. Passport 150: Leave the Tower standing upright on a hard surface. 2) Passport: Open and empty the storage compartment. With the door wide open, look upwards into the top left of the `roof' of the storage compartment, and identify the two (2) fuse holders. [. . . ] 2) Passport: Open and empty the storage compartment. With the door wide open, look upwards into the top left of the `roof' of the storage compartment, and identify the two (2) fuse holders. Passport 150: Located above the AC input socket, remove the two screws securing the fuse holder cover plate at the lower right rear of the panel. 3) Passport / Passport 150: Carefully insert each fuse into its respective holder and secure. [. . . ]