User manual FENDER PRINCETON STEREO CHORUS

[. . . ] This effect is particularly dramatic at high GAIN settings. At high LIMITER and GAIN settings a very dynamic effect can be achieved by varying pick attack. (i. e. : The harder you pick, the cleaner the note. Also harmonic content will increase as notes are allowed to sustain. [. . . ] A lower number corresponds to a slower rate of sweep. SELECT- Activates the stereo CHORUS mode. NOTE: This switch disables the Chorus Select Footswitch. DEPTH-Adjusts the intensity of the chorus effect. A lower setting will introduce a subtle yet distinct effect whereas a higher setting will create a more dramatic effect. RATE and DEPTH controls set midway or higher, a variety of vibrato/tremolo type effects can be achieved. CHORUS INDICATOR-This LED is illuminated when the stereo chorus is active. The intensity of the LED is modulated by the chorus sweep LFO to give a visual indication of the sweep rate. FOOTSWITCH- Plug-in connection for remote footswitch to activate the OVERDRIVE mode and to switch the stereo CHORUS on and off. For proper operation of the footswitch, both M. NOTE: Any good quality patch cord will work with the remote footswitch, however a speaker grade cord is preferable to a coax guitar cord when it's available. T. EFFECTS LOOP MONO SEND-This jack provides an unbalanced mono output signal from the preamp at a point before the internal effects circuits (REVERB & CHORUS). This output can be used in conjunction with the U. MONO RETURN as a patch point for mono effects devices. (SEE: EFFECTS LOOP CONNECTION DIAGRAMS). The MONO SEND can also be used to feed recording and sound reinforcement mixers a dry signal. (For a signal with internal REVERB and/or CHORUS, use the V. STEREO SEND jack. ) Additionally this output can be used to drive another PRINCETON CHORUS as a slave amp. This is done by connecting a standard guitar cord from the MONO SEND jack of the master amplifier to the MONO RETURN jack of the slave. EFFECTS LOOP MONO RETURN -This unbalanced jack inputs signal to the stereo chorus and reverb generating circuitry, which drives the stereo power amp section. It automatically disconnects the preamp signal when used. This is useful when using the Mono Effect Loop option or when using the PRINCETON CHORUS as a slave amplifier for a mono signal source. [. . . ] (Eliminate any effect pedals and try another guitar cord. ) If, after checking all of the above, the system is still not performing correctly, consult your Fender Service Dealer. PRINCETON CHORUS SPECIFICATIONS PART NUMBER: 22-5700 DIMENSIONS: Height: 17-1/2" Width: 22-3/8" Depth: 10-3/16" WEIGHT: 38 lbs. (44 cm) (57 cm) (26 cm) (17. 2 kg) INPUT IMPEDANCE: INPUT 1 only-1 meg Ohm. NOMINAL LEVEL: INPUT 1 only-100mv. , INPUT 2-200mv. RATED LOAD IMPEDANCE: 8 Ohms per channel. [. . . ]