User manual FENDER REISSUE 54 ESQUIRE

[. . . ] CONNECT TO AN AC POWER SUPPLY IN ACCORDANCE WITH THE VOLTAGE AND FREQUENCY RATINGS AS SHOWN ON THE REAR PANEL OF THE UNIT. SWITCH OFF POWER TO THE UNIT AND UNPLUG THE AC POWER LINE CORD BEFORE CLEANING THE UNIT'S EXTERIOR. ALLOW THE UNIT TO COMPLETELY DRY BEFORE RECONNECTING IT TO THE AC POWER SUPPLY. KEEP 6 INCHES (15. 3 cm) OF UNOBSTRUCTED AIR SPACE BEHIND THE UNIT TO ALLOW FOR PROPER COOLING BY VENTILATION. [. . . ] Remember that the TAP button can always be used to key in the chorus rate by feel two TAPs set the time it takes for the chorus LFOs (Low Frequency Oscillators) to go through one cycle. Note: Although this is a stereo chorus, both of the chorus voices move at the same rate. Adjusts the amount of Doppler shift and how apparent the effect sounds. Select between 1. 0 for no apparent effect and 10. 0 for maximum effect. Adjusts the average delay time of the moving chorus taps. Select 1. 0 for a transparent natural sound and 10. 0 for a synthesized sound with a noticeable delay between the original and chorus signals. Use higher settings for a doubling effect. Adjusts the phase relationship between the two chorus Low Frequency Oscillators. Select 1. 0 and the two voices of the chorus are in phase and the effect is minimal. Select 10. 0 and the LFOs are out-of-phase and the maximum stereo effect is achieved. For Sine Chorus, this control is usually set at 5. 5 for the ideal sound. Continuously adjusts the smoothness of the tremolo waveform. Select between 1. 0 for a subtle and natural effect and 10. 0 for a choppy effect. ~~ ~~ ~~ ~ ~~ ~~ ~~ ~~ ~~ ~~ ~ ~~ ~~ ~~ ~~ ~~ ~~ ~ ~~ ~~ ~~ ~~ ~~ ~~ ~ ~~ ~~ ~~ ~~ ~~ A sine-wave tremolo effect that can be used to approximate grid-bias tremolo or repeat percussion as found in a Tweed Tremolux. Select between 1. 0 for 0% wet (no effect) and 10. 0 for 100% wet (all effect). The increment of change gradually increases from 0. 01 Hz for the slowest rate to 0. 08 Hz for the fastest rate. Remember that the TAP button can always be used to key in the tremolo rate by feel two TAPs set the time it takes for the tremolo LFOs (Low Frequency Oscillators) to go through one cycle. Adjusts the amount of volume drop and how apparent the effect sounds. Select between 1. 0 for no apparent effect and 10. 0 for maximum effect. Select 1. 0 and the LFO will modulate the guitar signal so much that the phase is flipped, giving a more extreme character. Select 10. 0 and the LFO is limited to just modulating the volume. Continuously adjusts the smoothness of the tremolo waveform. Select between 1. 0 for a subtle and natural effect and 10. 0 for a choppy effect. [. . . ] \/ End of System Exclusive File Byte End of System Exclusive Message Dump ID 01H 02H 03H 1 2, 7& 85 76 1, Description Transmit the Utilities Transmit the Selected Preset Transmit all the Presets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V HF LG QH SS $ /$ 8 1$ 0 NI WT - R E BY C. . . . . . . . . . . . . . . . . . JQLWRRKVHOEXRU7 To locate MIDI resources online, visit www. midi. org . Turn MASTER VOLUME, TRIM, GAIN, VOLUME, TREBLE, MIDDLE, BASS and Guitar Volume ALL above minimum. Is there anything plugged into the HEADPHONE jack? [. . . ]