User manual FENDER ROC PRO 700

[. . . ] Read through this manual and familiarize yourself with the Roc Pro's many features, then experiment!Take the time to uncover the broad spectrum of tone colors available via the front panel's EQ and GAIN controls. And don't forget the VOLUME and TONE controls on your guitar! [. . . ] A lower setting will notch the midrange to produce the "crunch" sound characteristic in most heavy metal music. BASS - Adjusts the amount of low frequency boost or cut in the Drive channel. This control is post distortion and is useful for adjusting the amount of "thump" or "chunk" produced by the drive channel. DRIVE SELECT - When this button is pressed, the amp switches from the Normal channel to the Drive channel. VOLUME - Adjusts the overall volume of the drive channel . M. REVERB - Adjusts the amount of reverb present in both the Drive and Normal Channels. FOOTSWITCH (INCLUDED) - Plug-in connection for the remote footswitch to select between the normal and drive channels and to turn the reverb effect on and off. Using the footswitch overrides the front panel select buttons. NOTE: Any good quality patch cord will work with the remote footswitch, however, a speaker grade cord is preferable to a coax guitar cord. POWER INDICATOR - This LED is illuminated when the power is ON. POWER SWITCH - Turns the AC power ON and OFF. 7 Roc Pro 700 REAR PANEL FUNCTIONS LINE OUT SEND ­16dBv LOW GUITAR ­7dBv MED LINE +4dBv HIGH RETURN LEVEL EFFECTS LOOP MODEL TYPE: PR 242 700 Roc·Pro A PRODUCT OF: FENDER MUSICAL INSTRUMENTS CORP. , CORONA, CA 91720 ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE CAUTION: CHASSIS SURFACE HOT WARNING: TO REDUCE THE RISK OF FIRE OR SERIAL NUMBER 200W AVIS: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR ATTENTION: SUPERFICIE DE CHASSIS CHAUDE MADE IN U. S. A. A B C D E A. LINE CORD - the Roc Pro 700 is equipped with a grounding type supply cord to reduce the possibility of shock hazard. Be sure to connect it to a grounded AC receptacle. LINE OUT - This jack provides an output signal taken directly off the amplifier output and speaker and is used for direct connection to recording and sound reinforcement equipment. [. . . ] Is the volume control on the instrument turned up?Is the instrument properly plugged into the amplifier?(Eliminate any effects pedal and try using another cord. ) If after checking all of the above your amplifier is still not performing correctly, consult your authorized Fender Service Center. 9 Roc Pro 700 Specifications TYPE: PART NUMBER: PR 242 22-6876 22-6806 22-6866 22-6836 >1 M 100mV 65 W into 8 at 5% THD Nominal Level; Selectable +4, -7, -16 dBV Output Impedance: 1. 2 k max Input Impedance: 100 k 100V AC, 50/60 Hz, 200W 120V AC, 60 Hz, 200W 230V AC, 50 Hz, 200W 240V AC, 50 Hz, 200W 8 12" Fender Special Design (P/N 025923) 2 Button Footswitch, Controls Gain and Reverb On/Off Height: Width: Depth: Weight: WARNING: 16. 5 in 20. 5 in 9. 75 in 30 lbs 41. 9 cm 52. 0 cm 24. 7 cm 13. 6 kg (100V) (120V) (230V) (240V) INPUT IMPEDANCE : NOMINAL LEVEL: POWER OUTPUT: EFFECTS LOOP: POWER REQUIREMENTS: SPEAKER: FOOTSWITCH: DIMENSIONS: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. [. . . ]