User manual FESTOOL 0F 1400 EBQ

[. . . ] 3 Noise and vibration information The typical values determined in accordance with EN 60745 are: Sound-pressure level 82 dB(A) Sound-power level 93 dB(A) Measuring uncertainty allowance K = 3 dB Wear ear protection!Overall vibration levels (vector sum for three directions) measured in accordance with EN 60745: Vibration emission level (3-axis) ah = 3. 0 m/s² The emission values specified (vibration, noise) were measured in accordance with the test conditions stipulated in EN 60745 and are intended 13 1 Intended use The routers are designed for routing wood, plastics and similar materials. Aluminium and plasterboard can also be processed with corresponding cutters such as are listed in the Festool catalogues. [. . . ] Do not tighten the nut until a milling cutter has been fitted. - Press the stop cylinder against one of the three sensing stops of the pivoted turret stop (1. The individual height of each sensing stop can be adjusted with a screwdriver: Sensing stop min. 3) down so that it shows 0 mm on the scale (1. If the base position is incorrect, this can be adjusted with the screw (1. B) Setting the milling depth The desired milling depth can be set either with the quick depth adjustment or with the fine depth adjustment. - Quick depth adjustment: Pull the stop cylinder (1. 7) up until the pointer shows the desired milling depth. Turn the adjusting wheel to the next mark on the scale to adjust the milling depth by 0. - Fit the extractor hood to the router base by first inserting the two tenons (3. 1) on the extractor hood into the recesses (3. 2) on the router base, then place the extractor hood on the router base and close the lever (3. 3) in the extractor hood can be opened by turning the segment (3. For optimised dust extraction, the recess with the rotating segment must be closed during work. A Festool dust extractor with an extractor hose diameter of 36 mm or 27 mm (36 mm recommended due to the reduced risk of clogging) can be connected to the extractor connector (3. KSF-OF chip catcher Using the KSF-OF chip catcher (sometimes included in the scope of delivery), the efficiency of the extraction can be increased when routing edges. The hood can be cut off along the grooves using a hacksaw and can thus be reduced in size. The chip catcher can then be used for interior radiuses up to a minimum radius of 40 mm. 6 Working with the machine Always secure the workpiece in such a manner that it cannot move while being sawed. The machine must always be held with both hands by the designated handles (1. For work that generates dust, wear a dust mask. always advance the router in the direction opposite to the direction of rotation of the cutter (counter-routing)! [. . . ] Damage resulting from, in particular, normal wear and tear, overloading, improper handling, or caused by the user or other damage caused by not following the operating instructions, or any fault acknowledged at the time of purchase, is not covered by the warranty. Complaints will only be acknowledged if the equipment has not been dismantled before being sent back to the suppliers or to an authorised Festool customer support workshop. Store the operating instructions, safety notes, spare parts list and proof of purchase in a safe place. in addition , the manufacturer`s current warranty conditions apply. [. . . ]