User manual FESTOOL C 12 LI

[. . . ] ­ The charger and power tool are not intended for use by persons (including children) with limited physical, sensory or mental ability or without sufficient experience and/or knowledge, unless they are supervised by a person responsible for their safety or have been instructed on how the Children should always be supervised to ensure that they do not play with the charger or the power tools. Switch of the power tool immediately if the tool is blocked. Always be prepared for high reaction torques that can cause kickback. The tool blocks if: - the power tool is overloaded or - it becomes jammed in the workpiece being processed. [. . . ] It can be mounted on a wall using two screws (e. Round head or flat head screw with shank diameter of 5 mm) (see Fig. Tool chuck CENTROTEC WH-CE [4] The tool chuck CENTROTEC WH-CE allows you to change tools with a CENTROTEC shank in a matter of seconds. Otherwise there is a risk of damaging the gear unit. 3 Fastening Adjust the switch so that [1-7] its marking faces the screw [1-6] symbol. The torque can be adjusted in this position. l The switch-over function only works if the machine is switched off. X Adjust the torque accordingly at the torque [1-1] wheel: Position 1 = low torque Position 25 = high torque The machine switches off when the preset torque is reached and an acoustic signal sounds. The machine only continues running when the on/off switch is [1-9] released and then pressed again. 4 Drilling Adjust the switch [1-7] so that its marking faces the drilling symbol [1-5]. Tool has sharp edges and can cause cutting injuries during a tool change. 4 Eccentric attachment DD-ES [7] The eccentric attachment (in part, additional equipment) permits screwdriving near edges with bits according to DIN 3126. 5 Tool holder in the drill spindle [8] Bits can be inserted directly in the hexagon socket holder on the drill spindle to shorten and reduce the weight of the machine. 1 On/Off switch [1-9] Press = ON, release = OFF L The speed of the machine depends on how far the on/off switch is pressed in. The LED lamp [1-3] lights up when the on/off switch [1-9] is pressed and lights up the working area. 3 Acoustic warning signal Acoustic warning signals sound and the machine switches off in the following operating states: Risk of injury, electric shock X Always disconnect the battery pack before any type of work on the machine!X You must allow the machine to cool before using again. X Once the battery pack has cooled, perform a functional check using the charger. Use only original Festool accessories and Festool consumable material intended for this machine because these components are designed specifically for the machine. Using accessories and consumable material from other suppliers will most likely affect the quality of your working results and limit any warranty claims. Machine wear or your own personal workload may increase depending on the application. Protect yourself and your machine, and preserve your warranty claims by always using original Festool accessories and Festool consumable material! [. . . ] Complaints can only be accepted if the tool is returned while still assembled to the supplier or an authorised Festool Customer Service workshop. Keep the operating manual, safety instructions, spare parts list and purchase receipt in a safe place. Otherwise the current warranty conditions of the manufacturer shall apply. Note Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation. [. . . ]