User manual FESTOOL CS 70 EB

[. . . ] Bench-mounted circular saw and circular trimming saw PRECISIO CS 70 E, CS 70 EB The specified illustrations are at the beginning of this operating manual. Foldaway legs On/off switch Cable holder Table insert Rotary knob for adjusting the fence Spacer wedge Stop lever Cutting depth adjuster End cap Groove Rotary knob for adjusting the protective cover [1-12] Knobs for adjusting the foldaway legs Warning of general danger Risk of electric shock Wear ear protection. The PRECISIO is designed as a transportable electric power tool for sawing wood, plastics, panel materials made of wood and similar materials. Special aluminium cutting blades supplied by Festool allow you to use these machines to saw aluminium. [. . . ] Fitting the protective cover Pull the spacer wedge [1-6] sharply upwards [7-2] to move to the top catch position. Secure the top protective cover supplied to the spacer wedge in this position using the rotary knob [1-11]. 2 On/Off switch We recommend using a 16 A fuse because of the performance of the motor. Restart protection The integral undervoltage release prevents the machine from automatically starting up again after an interruption in power when the machine is used in continuous operating mode. The machine will have to be switched back on in this case. 2 Set-up position Always move the saw to set-up position before making any adjustments: The saw is locked in rest position on delivery. Turn the rotary knob [2-6] anticlockwise to release the lock and pull the saw forwards. The saw is locked in the front position. 3 Adjusting the cutting depth Proceed as follows to adjust the cutting depth in set-up position to any setting between 0 70 mm: Turn the cutting depth adjuster [1-8]. Set a cutting depth 2 - 5 mm greater than the thickness of the workpiece to produce a clean cut. 4 Adjusting the mitre angle The saw blade can be tilted between 0° and 45° in set-up position: Unscrew the rotary knob [2-4]. Adjust the mitre angle using the rotary handle [2-3] with reference to the scale [2-5]. The saw blade can be tilted 2° beyond the two end positions for precision trimming work (undercuts on abutting edges). press and hold the button [2-2] in the end position. The saw blade can now be tilted from -2° to 47° using the rotary handle [2-3]. Reach underneath the table insert [1-4] from the back and remove by lifting away from the back of the table. Remove the hexagon wrench [5-3] from the store on the base [5-6] and insert in the saw blade retaining screw. Press and hold the spindle stop [5-2] (behind the saw blade) and use the hexagon wrench to turn the saw shaft until the spindle stop [5-2] engages and the saw shaft locks. The saw blade retaining screw has a lefthanded thread. Firmly turn the saw blade retaining screw clockwise and remove the clamping flange and the saw blade. Risk of injury Observe the rotation direction when attaching a new saw blade: the rotation direction on the saw blade [5-4] must correspond with the rotation direction on the machine. Secure the saw blade and the flange to the saw shaft using the saw blade retaining screw. [. . . ] - A damper allows the saw unit to retract evenly along the entire cutting length. If this is not the case, the damper can be adjusted through the hole [3-5]. filter cleaning (CS 70 EB only) You should clean the air intake filter [3-2] if the temperature monitor (see 7. 1) triggers shutdown cycles more frequently without the machine being overloaded excessively. [. . . ]