User manual FESTOOL CS 70 VL

[. . . ] 1) The extension table CS 70 VB can be fitted to the base table to enable exact cuts with a stop up to a cutting width of 680 mm. 1) in the table frame, push down and tighten with knurled nut (2. [. . . ] 2) The extension table CS 70 VL can be mounted on the rear of the CS 70 EB to provide a safe support when sawing longer work pieces. 6) to rear of frame with enclosed bolts, square nuts and washers. If a CS 70 ST sliding table is already fitted the fitting angle for the extension table is placed on the fitting angle for the sliding table on the side of the sliding table and both fitting angles fastened together (on top of one another). The enclosed 4 mm washer then has to be inserted beneath the fitting angle on the other side. Lower the extension table onto roughly the same level as the saw table and insert the end of the support (3. 1) in the table frame, press down and fasten with knurled nut (3. Push extension table onto roughly the same level as the saw table and fasten with left and right rotary knobs (3. Align the table lengthener on the direct join with the table base to a position slightly below the surface of the table base (check by placing the stop ruler on the table base). Check that the entire surface of the extension is flat with the stop guide. Slightly raise the rear of the extension table and remove ends of supports from slots. 3) Precise sawing work with large work pieces is only possible with a correctly fitted rippingcut fence CS 670 LA (Fig. The following adjustments are possible with the ripping-cut fence: Handle (4. [. . . ] Set fence to exact size with fine adjustment using rotary knob (4. The fence is hereby moved by 1/10 mm for every scale mark. [. . . ]