User manual FESTOOL LA

[. . . ] ­ Check the plug and the cable regularly and should either become damaged, have them replaced by an authorised after-sales service workshop. Stroboscopic light can cause epileptic seizures. Do not use this machine if you are susceptible to epileptic seizures. ­ Do not look into the stroboscope light. [. . . ] X Push the saw blade [3-4] into the opening as far as the stop with its teeth in cutting direction [3-2]. A loose saw blade can fall out and cause an injury. L In the case of very short saw blades, it is advisable to remove the saw table (see chapter 7. Risk of accident X The mains voltage and the frequency of the power source must correspond with the specifications on the machine's name plate. X In North America, only Festool machines with the voltage specifications 120 V/60 Hz may be used. The electric power tool has one button [1-2] on each side for switching on/off. Ejecting saw blade L When ejecting the saw blade, hold the electric power tool such that no persons or animals can be injured. x Push the saw blade ejection [3-3] forwards as far as the stop. If the saw blade is not ejected: run jigsaw 3 - 10 seconds at a high speed. Actuate saw blade ejector mechanism [3-3] once again. 2 Using the chip guard The chip guard [3-1] prevents chips flying away and improves the efficiency of the chip extraction system. Plasterboard) Damage to machine through dust penetration, risk of injury X Do not work overhead!When working on small or thin workpieces, always use a stable base, or the CMS module (accessory). When working, hold the electric power tool by the handle and guide it along the desired cutting line. For precise cuts and smooth running, use two hands to guide the electric power tool. Freely guided sawing along a scribe mark The triangular shape of the splinterguard [41] points to the cutting line of the saw blade. This facilitates sawing along a scribe mark. The stroboscope light may make it difficult to determine the saw blade position Risk of injury X Ensure the work area is well illuminated. Use only original Festool accessories and Festool consumable material intended for this machine because these components are designed specifically for the machine. Using accessories and consumable material from other suppliers will most likely affect the quality of your working results and limit any warranty claims. Machine wear or your own personal workload may increase depending on the application. Protect yourself and your machine, and preserve your warranty claims by always using original Festool accessories and Festool consumable material! [. . . ] EU only: European Directive 2002/96/EC stipulates that used electric power tools must be collected separately and disposed of at an environmentally responsible recycling centre. We offer a warranty for material and production defects for all our tools in accordance with the locally applicable legal provisions, but for a minimum of 12 months. Within the EU member states, the warranty period is 24 months (verification through invoice or delivery note). Damage caused by the operator, natural wear, overloading, incorrect handling or through the use of the equipment not specified in the operating manual, or damage which was known at the time of purchase, is not covered by the warranty. [. . . ]