User manual FESTOOL LEX 2 125-7

[. . . ] Ignoring warning notes and instructions may result in serious injuries. Keep all of the attached documents and pass on the documentation if the machine changes ownership. Untidiness in working areas increases the risk of an accident. Please take your surroundings into consideration. [. . . ] Using other tools or accessories can pose a risk of injury. This pneumatic tool corresponds to the relevant safety regulations. Pairs should only be carried out by a qualified specialist. The operator is otherwise at risk of an accident. Only trained and qualified persons are permitted to set up, adjust and operate this air tool. Persons without the relevant qualifications and training are more likely to cause accidents. Modifications may reduce the effectiveness of safety devices and pose a greater risk to operating personnel. Prepare to counteract normal or sudden movements - hold the machine with both hands. 2 Machine-related safety instructions - The manufacturer's handling and processing instructions must be observed without fail if explosive or self-igniting dusts are likely to occur during sanding. - If dust dangerous to health is produced during sanding, the machine should be connected to an appropriate extraction device and the safety regulations that apply to the working material should be observed. - The operating pressure should not exceed 6. - The machine should only be operated with sandpaper. Using the Festool service unit VE guarantees this. - Only use original Festool accessories. - Wear suitable protection such as ear protection, safety goggles, a dust mask for work which generates dust, and protective gloves when working with raw materials and when changing tools. - The permissible rotational speed of the accessory must be at least as high as the maximum speed specified on the machine. Accessories that rotate faster than the permissible level can rupture. - Proceed with caution in unfamiliar surroundings that may contain electricity or other supply cables that harbour hidden dangers. Make sure that there are no electrical cables, gas pipelines or similar that, if damaged, could pose a hazard when the machine is used. 3 Residual risks In spite of compliance with all relevant design regulations, dangers may still present themselves when the machine is operated, e. Workpiece parts being thrown off, · Parts of damaged tools being thrown off, · 4 Noise and vibration information Typical values established in compliance with EN ISO 15 744/EN ISO 8662: Sound pressure level 70 dB(A) Measured acceleration LEX 2 125/7, LEX 2 185/7 < 2, 5 m/s² LEX 2 125/3, LEX 2 150/3 = 3, 0 m/s² LEX 2 150/11 = 4, 0 m/s² LEX 2 150/7 = 4, 5 m/s² Uncertainty K = 1, 5 m/s² The noise level can exceed 85 dB(A) during work. The emission values specified (vibration, noise) were measured in accordance with the test conditions stipulated in EN ISO 15 744/EN ISO 8662 and are intended for machine comparisons. [. . . ] For a weekend, introduce 1 or 2 drops of lubricating oil into the compressed-air supply (5. 4 Replacing the silencer The silencer on the IAS 2 connecting piece must be replaced at regular intervals to maintain the power of the pneumatic tool. 4) be cleaned using a small pipecleaner brush or a cloth once a week (especially when sanding resin filler). 6 Accessories, tools Use only original Festool accessories and Festool consumable material designed for this machine because these system components are designed specifically for the machine. [. . . ]