User manual FESTOOL LRS 93 M

[. . . ] Do not use the pneumatic tool for purposes for which it was not intended. Do not wear loose fitting clothing or jewellery. rubber gloves and non-slip footwear are recommended for outdoor work. Long hair should be protected with a hair net. [. . . ] Persons without the relevant qualifications and training are more likely to cause accidents. Safety devices and pose a greater risk to operating personnel. Prepare to counteract normal or sudden movements hold the machine with both hands. Machine-related safety instructions ­ If potentially explosive or self-igniting dust is produced during sanding, the processing instructions of the material manufacturer must be observed under all circumstances. ­ If dust dangerous to health is produced during sanding, the machine should be connected to an appropriate extraction device and the safety regulations that apply to the working material should be observed. ­ The operating pressure should not exceed 6. ­ The tool should only be operated with sandpaper. Using the Festool service unit VE guarantees this. ­ Wear suitable protection such as ear protection, safety goggles, a dust mask for work which generates dust, and protective gloves when working with raw materials and when changing tools. ­ The permissible rotational speed of the accessory must be at least as high as the maximum speed specified on the machine. Accessories that rotate faster than the permissible level can rupture. ­ Proceed with caution in unfamiliar surroundings that may contain electricity or other supply cables that harbour hidden dangers. Make sure that there are no electrical cables, gas pipelines or similar that, if damaged, could pose a hazard when the machine is used. 3 Residual risks In spite of compliance with all relevant design regulations, dangers may still present themselves when the machine is operated, e. : ­ Workpiece parts being thrown off, ­ Parts of damaged tools being thrown off, ­ Noise emission, ­ Wooddust emission. 4 Emission levels Levels determined in accordance with EN ISO 15744/EN ISO 8662 are typically: Sound pressure level Noise level Measuring uncertainty allowance Operating noise Damage to hearing X Wear ear protection!Levels determined in accordance with EN ISO 15744/EN ISO 8662 are typically: Measured acceleration < 2, 5 m/s2 Uncertainty K = 1, 5 m/s2 The emission values specified (vibration, noise) were measured in accordance with the test conditions stipulated in EN 60745 and are intended for machine comparisons. They are also used for making preliminary estimates regarding vibration and noise loads during operation. the emission values specified refer to the main applications for which the air tool is used. If the air tool is used for other applications, with other tools or is not maintained sufficiently prior to operation, however, the vibration and noise load may be higher when the tool is used. Take into account any machine idling times and downtimes to estimate these values more accurately for a specified time period. This may significantly reduce the load during the machine operating period. [. . . ] Machine wear or your own personal workload may increase depending on the application. Protect yourself and your machine, and preserve your warranty claims by always using original Festool accessories and Festool consumable material! festool offers the appropriate sanding and polishing attachments for every application. The order numbers of the accessories and tools can be found in the Festool catalogue or on the Internet under "www. [. . . ]