User manual FESTOOL MFK 700 EQ

[. . . ] all Festool routing tools fulfil these requirements. - The maximum rotational speed specified on the tool must not be exceeded and the rotational speed range must be observed. - Do not use cracked or deformed router bits. - Do not clamp tools with an unsuitable shank diameter in the clamping collet. [. . . ] Other router tables are included in the accessories programme. 5° so that the surface coating is not damaged during edge routing. b) Inserting the tool · Insert the routing tool [6-3] into the open clamping collet as far as possible, but at least up to the mark ( ) on the shank. 4 Changing the clamping collet Only compatible tools can be used in combination with the clamping collets supplied. Remove the locking nut from the spindle together with the clamping collet [7-3]. Do not separate the locking nut and clamping collet as these form a single component. Attach a different clamping collet with locking nut to the spindle. Do not tighten the locking nut until a router bit is inserted. When performing work that generates dust, always wear a dust mask. Extraction hoods are supplied for both router tables; a Festool extractor (extractor hose with a diameter of 27 mm) can be connected to these extraction hoods. the dust extractor (extractor hose with dia. 27 mm) can also be attached to the large surface router table or the side stop depending on the application. Risk of accident - the routing tool may be hot after use and has sharp edges. Allow the tool to cool before changing. Wear protective gloves when changing tools. Unscrew the locking nut [6-2] using the openend wrench (size 19) until you are able to remove The machine is then guided in such a way that the sensor rests against the workpiece. Always secure the workpiece in such a manner that it cannot move while being routed. The side stop can only be fitted to the large surface router table without a fitted extraction hood [4-2]. Secure both guide rods [9-5] with the two rotary knobs [9-2] on the side stop. Insert the side stop into the grooves on the router table to the required distance and secure the guide rods by turning the rotary knob [9-1]. Loosen the screws [9-2] and turn the green wheel on the fine adjuster [9-3]. The distance between each line on the rotary wheel is 0. [. . . ] Otherwise the respective, current warranty conditions of the manufacturer shall apply. Note Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation. We declare at our sole responsibility that this product is in conformity with the following standards or standardised documents: EN 60745-1, EN 60745-2-17, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3 in accordance with the regulations 2006/42/EC, 2004/108/EC. REACH for Festool products, their accessories and consumables REACh is a European Chemical Directive that came into effect in 2007. [. . . ]